tricomb
Bluelight Crew
NEVER add heat to pharmaceuticals.... And if you're heating them and then running them through a micron filter while the solution is still even WARM, you are defeating the entire purpose of micron filtration and are letting all the non-soluble fillers pass through as you've made them temporarily liquidated but soon to resolidify likely in your bloodstream in the fine blood vessels of your lungs leading to premature death via pulmonary edema for example, all preventable, all stuff that the cold water + micron filter would have filtered out.
Opioids are FREELY soluble in water, and of all opioids, hydromorphone!?!? It's got one of the highest solubilities I have ever seen, topping out saturated at like 333mg per mL of water... Compared to the 50mg / mL of morphine gets.... dilaudid is one of the most water soluble drugs and one of the EASIEST opioids to prep, requiring nothing more than sterile equipment, including sterile cold water for injection. And if you need anywhere near a full 1mL of water, you have a serious drug problem if your injecting maximum capacity at 333mg/mL, a dose that would probably kill a room full of people if injected.
By the way, "flash boiling" does not mean applying heat for 10 seconds.... I bet in those 10 seconds you'll have destroyed more than 50% of the hydromorphone because it was not meant to be heated. DON'T APPLY HEAT TO PHARMACEUTICALS. Do a search, I wrote an entire thread on this topic that's far more detailed on why, picture proof and everything.
Opioids are FREELY soluble in water, and of all opioids, hydromorphone!?!? It's got one of the highest solubilities I have ever seen, topping out saturated at like 333mg per mL of water... Compared to the 50mg / mL of morphine gets.... dilaudid is one of the most water soluble drugs and one of the EASIEST opioids to prep, requiring nothing more than sterile equipment, including sterile cold water for injection. And if you need anywhere near a full 1mL of water, you have a serious drug problem if your injecting maximum capacity at 333mg/mL, a dose that would probably kill a room full of people if injected.
By the way, "flash boiling" does not mean applying heat for 10 seconds.... I bet in those 10 seconds you'll have destroyed more than 50% of the hydromorphone because it was not meant to be heated. DON'T APPLY HEAT TO PHARMACEUTICALS. Do a search, I wrote an entire thread on this topic that's far more detailed on why, picture proof and everything.