• 🇬🇧󠁿 🇸🇪 🇿🇦 🇮🇪 🇬🇭 🇩🇪 🇪🇺
    European & African
    Drug Discussion

    Welcome Guest!
    Posting Rules Bluelight Rules
  • EADD Moderators: Shambles

POWDERED Ammonia Freebase - REROCK PROCESS?

shamone

shamone

Bluelighter
Joined
Dec 11, 2011
Messages
219
Hey,

Before I get told to YTFSE, I already have! I have searched on the search engine here, as well as others, but all I am finding is either just threads / methods on how to make powdered coke into crack / freebase. Or methods to clean / wash crack that has too much cuts and baking soda in it!

What I need to know is how I would go about turning ALREADY MADE cocaine freebase that has been made with a proffesional wash with ammonia, that is very pure already, but happens to have been crushed into a powder back into one or two nice hard rocks?

I am sure a fair few of you know ways of doing this, so would be massively appreciated if you could tell me or give me some advice! I thank any kind people who can help me in advance!

Oh and also, if and when any of you do reply, can you tell me the quantities of ingredients needed, rather than just 'use SOME water, or A BIT of acetone etc etc' lol!

Thanks again in advance!

Shamone
 
because i like to smoke it out of an ash pipe made out of a soda can...i know some people will think im crazy but i just prefer it! And when its finely powdered its harder to get all the powder in the right spot on top of the ash, whereas a rock is easy to just snap off a piece and place it exactly where i want it!!

Someone must know how to do this!! Please help!
 
just fukin smoke if you haven't already .

Must be summat really wrong if you haven't i couldn't have crack on me for a minute without doing it .
 
That's really simple....Just put it in water, the amount of water doesn't matter, just enough that it will fit in there...Use a big spoon maybe...Put it all in there and just heat it until it boils and the powder melts into little pools.....Give it a few minutes to start to solidify and push it to the side with a paperclip, a coin...whatever....If you're just trying to turn crushed crack back into a rock, that's it!
 
Really? IME crack just sits there in water, not doing anything...Are you saying that leaving it in water it will liquefy over time? w

Either way, "re-rocking" crack this way is a pretty common practice that people use when they get shitty crack, because sometimes it will get certain cuts out of the crack, in which case you'll end up with a smaller amount than you started with....sometimes, whatever the cut is will melt right along with the crack and come back...
 
lol I wouldnt be flushng this stuff mate!! And it has been smoked, and it was fucking awesome, some of the best iv tried, but i was just wondering for the next time i get it how to do what i asked in the OP!

Thanks to all of you that made constructive comments!!! ;)
 
Yeah I was a bit harsh, haven't smoked any in months and your post was hella frustrating!
As satisfying as big rocks are it's all about the surface area my friend :)
 
i do know what you mean, i just hate the metalic taste of gauze when using a stem pipe, and i actually find u get a better and stronger hit with a ash pipe made out of a can (if made properly) with the only downside being there are no bonus pipes after having a session from cleaning out the pipe!

hence my wanting rocks, which can be broken down into smaller pieces and placed on the ash, but i find straight powder is very tricky to get all of it where u want it on the can, and trust me this was not the kind of stuff i wanted to lose even the tiniest bit of!
 
Thanks for the only answer to the question answered....Unfortunately, I am not Chris Tarrant, so you wont be walking away a MILLLIIINAAAIRREEE!!! But at least you have the knowledge that u guided someone who asked a simple question and gave them the answer, rather than telling me to smoke it or flush it....8(
 
No problem man! Actually has me craving a rock!8o

I don't like getting it all crumbly myself either! Don't know if you've tried it yet, but obviously you only want to heat it enough that the crack melts, you don't want to continue to keep heating it until it vaporizes and floats away! Where I'm from, sometimes the crack is such garbage that it doesn't even really melt. It's turns into black ash when you try to smoke it...It is real though, it just has something in it that doesn't melt that they put in there to add volume...Just melting it into the water gets a lot of that crap out...the garbage sinks to the bottom and the good stuff stays floating like a bubble on top....Sometimes it ends up being 1/3 of the original size, but 3 times better!

Glad to be a service though!
 
You must log in or register to reply here.
Top