• MDMA &
    Empathogenic
    Drugs

    Welcome Guest!
  • MDMA Moderators: Esperighanto

Dissolving MDMA

Status
Not open for further replies.
neMMMM

neMMMM

Bluelighter
Joined
Nov 20, 2008
Messages
420
Location
EARTH
So I think I know the answer to my question but just want to confirm.

If someone were to dissolve mdma into water and then took that water and let it dry out on a plate, they should be able to scrape up the mdma again right?
 
that would hypothetically be a good idea for smuggling mandy into a festival

hypothetically
 
neMMMM said:
I'd rather not state the reason, would be violating bluelight rules ;)
Click to expand...
I see.
Be aware that it can take quite a bit of time for plain water to evaporate, even when using a plate with a very wide surface. Just to give you example, I once left a few vials of ketamine in a pyrex dish to air dry and after 8 horus it wasn't even half it's original volume(only 20mL if I recall). So I employed the use of a blowdryer and it was ready in 15 minutes :)
 
looks like he'll have to take a battery operated hairdryer to the festival then

hypothetically
 
That's what I was thinking a hair dryer or hot plate at very low temp. I will be in 90 degree weather, hopefully that helps. It won't be a lot of water, probably around 30ml. Will a gram dissolve into this?
 
why would you need to evaporate the water? just drink it surely, unless you want to sniff it which can be a waste.
 
I want to be able to judge my dose and not just gulp it down and guess. There will be more than one dose dissolved in this.
 
It would definitely be better to leave it in the water. A few simple calculations beforehand and a measuring spoon can get you set for proper dosing just like dosing liquid medicine.

Lets say you have 1g and you want to dissolve in 100ml of water. Then you calculate the concentration like this.

Total mass of stuff / total volume of water. 1000mg / 100mL water = 10 mg/mL. So 1 mL of the water is 10mg of the molly.

Then, if you want a 100mg dose, you take 10mL, or 2 teaspoons (1 teaspoon is 5mL). If you want a 150mg dose, you take 15mL, or 3 teaspoons.

It's going to taste god-awful, but hey, doesn't all medicine?
 
Status
Not open for further replies.
Top