• BASIC DRUG
    DISCUSSION
    Welcome to Bluelight!
    Posting Rules Bluelight Rules
    Benzo Chart Opioids Chart
    Drug Terms Need Help??
    Drugs 101 Brain & Addiction
    Tired of your habit? Struggling to cope?
    Want to regain control or get sober?
    Visit our Recovery Support Forums
  • BDD Moderators: Keif’ Richards

Hydrocodone to oxycodone comparison and CWE question

O

Opiates<3

Bluelighter
Joined
Dec 27, 2011
Messages
69
Okay so for a few weeks now I have been taking hydrocodone almost daily for recreation. The dose that is perfect for me and that I have been taking for these past weeks was 40mg. But I have taken 50mg a few times and it was great, but 40mg is good enough for a nice buzz and a pretty good nod. And plus this way I get to save an extra pill.

Anyways I have taken a week break over Christmas vacation and I started using everyday again Monday and my tolerance is back to 40mg but it is stronger than usual. (obvious tolerance decrease) before my break I took a 30mg generic roxicodone (when I was using 50mg hydro a day for a week) and it was awesome. I snorted half and popped half. It was stringer than a 50mg hydro buzz. So obviously I found some more oxycodone today in the form of 5/325 percocets.

So to my question: how much oxycodone should I take to experience a buzz near the rage of 40mg hydro? I'm getting 15 pills tomorrow and I want to get the Most , strong buzzes that I can from them. I was thinking that I should take about 5 pills. So 25mg oxycodone , to get the effect I'm looking for.

Does this sound about right? Any imput about the differences in strength would be nice. As if any info on what mg I should take.
Also as you guys may know I am new here. I'm sorry if I posted anything against the rules. I have read the rules and don't see a problem with this post. I am also sorry if this is the right section.

Anyways thanks for the help in advance!

-ope<3
 
Last edited by a moderator:
Ime, the hydrocodone high is different than the oxycodone high.........imo, I would say 20mg of oxy equals about 35mgs of hydro...........oxy for me when taken orally gives me a very edgy feeling. Only way I like oxy & dont get an edgy feeling is by snorting it. Snorting gets me the euphoric feelings with oxy & morphine that I wouldnt get by taking them orally.
 
I don't understand what you mean by edgey? When I think of edgey I think of how adderal makes me feel but I know that can't be what your talking about here. Ime oxy feels like a fat high. I mean this by I feel like I have a huge blanket wrapped around me, because I feel warm and fuzzy. But hydro feels skinnier to me. Like not as big of a blanket if that makes any sense?
Thanks for your input! I will for sure start with 25mg of the oxy
 
We don't really encourage comparison threads here, as drugs do different things to different people. Some people like hydrocodone, and others like oxycodone.

Different strokes for different folks.
 
Sorry for the double post but is there a away to extract the apap out of Vicodin or Percocet without doing a cwe so the opiates the opiates don't turn into a liquid? So it's perfect for snorting? I wouldn't think there is bcuz I'm sure I woulda seen it on here by now

Ope<3
 
NeighborhoodThreat said:
We don't really encourage comparison threads here, as drugs do different things to different people. Some people like hydrocodone, and others like oxycodone.

Different strokes for different folks.
Click to expand...
So for future reference I shouldn't post comparison threads?
 
Opiates<3 said:
Sorry for the double post but is there a away to extract the apap out of Vicodin or Percocet without doing a cwe so the opiates the opiates don't turn into a liquid? So it's perfect for snorting? I wouldn't think there is bcuz I'm sure I woulda seen it on here by now

Ope<3
Click to expand...

It's a bit time consuming but not bad if you prepare in advance or do large batches - just CWE and evaporate the liquid. There are lots of ways you can do this at low enough temperatures that you don't destroy any of the active ingredients such as with hair dryers, ovens set very low (and/or with the door open) or using materials that evaporate more quickly than water does.
 
Cane2theLeft said:
It's a bit time consuming but not bad if you prepare in advance or do large batches - just CWE and evaporate the liquid. There are lots of ways you can do this at low enough temperatures that you don't destroy any of the active ingredients such as with hair dryers, ovens set very low (and/or with the door open) or using materials that evaporate more quickly than water does.
Click to expand...
How would I do such a thing? And what do you define as a "big" batch?
 
I have never CWE'd anything or evaporated liquid from any type of extraction so I'm not one to ask... just check to find out how soluble the specific drug is then use the least amount of water you can for it to be effective and add some low level heat such as with a hair dryer over (not in ;)) the liquid, put it in an oven if your oven goes low enough, etc... it will probably be a little time consuming to heat it slow enough to evaporate it without destroying the active ingredients. You should be able to find the temperature that the active ingredients start to degrade pretty easily. Regarding how large of a batch to do at once, that depends on what YOU consider worth it; no one can answer that for you.

This will probably turn out to be more of a novelty thing you do once or sparingly because with oxycodone and hydrocodone there is little advantage to snorting... the BA will be the same or less, you will probably lose a small amount in the process and it will take quite a bit of time and energy.
 
Cane2theLeft said:
I have never CWE'd anything or evaporated liquid from any type of extraction so I'm not one to ask... just check to find out how soluble the specific drug is then use the least amount of water you can for it to be effective and add some low level heat such as with a hair dryer over (not in ;)) the liquid, put it in an oven if your oven goes low enough, etc... it will probably be a little time consuming to heat it slow enough to evaporate it without destroying the active ingredients. You should be able to find the temperature that the active ingredients start to degrade pretty easily. Regarding how large of a batch to do at once, that depends on what YOU consider worth it; no one can answer that for you.

This will probably turn out to be more of a novelty thing you do once or sparingly because with oxycodone and hydrocodone there is little advantage to snorting... the BA will be the same or less, you will probably lose a small amount in the process and it will take quite a bit of time and energy.
Click to expand...
Hey I appreciate all of the information and yeah, it seems like that would be a little more time consuming than its worth! Thanks again!

-ope<3
 
^ yup it would be pretty time consuming and seeing as oxycodone has a higher oral bioavailability than nasal, and drinking a CWE hits you pretty instantly as liquid is absorbed really fast - not much point.

It depends how much water you use as to how long it would take - you want to use the minimum amount possible, as APAP is slightly soluble in water, but at the same time you need it to be fully liquid and not a paste or gloopy so it doesn't clog the filter. Realistically it's going to take a while to evaporate all the water off and as Cane said it's probably not worth it. I certainly wouldn't bother.
 
You must log in or register to reply here.
Top