Bupe Prepping suboxone strips for I.M. injection (did I do this right?)

[burn out]

So, I have micron filters and I followed the instructions in the micron filtering thread. I placed 3 suboxone strips into a syringe, drew up 10 mL of bacteriostatic water and let them dissolve. Then I attached a micron and sent the solution through the filter into a sterile vial. The resulting solution is mostly clear, slightly yellowish in color and tastes like those suboxone strips.

My question is, can I I.M. this? Is I.M. more dangerous than IV? How much of a risk am I taking here?

 

[burn out]

Well I hope I did it right because I did the shot. Now my next question is what concentration of suboxone to water should I aim for in my preparation?

 

[HaZeX]

Cant help on the mixing part of the subs...ANy other questions on an IM injection I can help with.

 

[burn out]

Well I guess I'd be curious to know what are the possible risks of injecting soboxone strips IM

 

[coojibug]

Look at the inactive ingredients of the strips. Corn starch, methylcellulose, manitol. You run the same risk of shooting strips as other pharms but probably higher. I would say you are injecting WAY to high a dose by any sane person's standards. I've heard people had trouble breathing above 4 mgs. Try and get the dose down in size. I always found 1 mg shots to act like full agonist. I'm outta the clinic now. But props on being sterile and using a micron filter. Oh, try and make your solution COLD before injecting.

I'll add more the possible health risks when i have more time.

 

[sekio]

Christ on the cross, this isn't a rapid response medical centre! Use google!