• BASIC DRUG
    DISCUSSION
    Welcome to Bluelight!
    Posting Rules Bluelight Rules
    Benzo Chart Opioids Chart
    Drug Terms Need Help??
    Drugs 101 Brain & Addiction
    Tired of your habit? Struggling to cope?
    Want to regain control or get sober?
    Visit our Recovery Support Forums
  • BDD Moderators: Keif’ Richards

Oxycodone-IV question

Status
Not open for further replies.

oxymoron131

Greenlighter
Joined
May 1, 2013
Messages
5
Hey all, new Member. Finally registered after many years of just searching I've decided to join you!!

What I am hoping to gather is an easy or simple way to prepare oxycodone 5mg NO APAP (small round white "M imprint") for iv use. Not one or two but more like the equivelent of 100mg or more.
Yes I know the dangers of iv and shooting pills, however I'm wondering what the best way to take a whole script of these and prepare for iv use. Thanks in advance:)
 
The best way to IV oxycodone is to eat it. this is not coming from some DARE, 12 step, or otherwise outside/bs viewpoint. Seriously, oxy is the one opiate that is like 90% available by mouth. you won get shit from IVing them, other than a shortened high (they dont produce a rush). Ive tried IVing 4 30IRs before, was a waste. seriously, eat them. and you do realize that even if this were somehow, in any measureable way, a success, you'd go thru a month's scrip in about 2 days, right?

welcome to bl!
 
IV oxy is generally a waste, it has 100% percent BA, but no rush.

Better off just taking some potentiators prior to popping the oxy. Or if you're comfortable with it, use the plugging ROA. I've heard from a fellow BL, this is their favorite ROA and they use Roxi's A LOT!
 
Like others above have stated, oxycodone has a very high oral and rectal BA so these are both obviously safer options than IV. Add to this that oxy does not produce a rush when injected and there's really no benefit to that ROA.

However, if you insist on doing this, I do have some advice. I have IV'd these little round pills before and it's a hassle, but doable. You are talking about a 100mg shot right? Now prepping them all and storing the solution?

First, crush them into a fine powder. From here you have two options.
Option 1: take 3-5 pills into a cooker. Add water and stir stir stir. Draw up the water, then take all the filler and leftover goop and put it aside. Add another 3-5 pills, and add the same water you just drew up. This way you can limit the amoint of water is in the end soluton. The problem with this is that not all the oxy comes out in the first rinse since there's sooo much filler, and since you can't get 100% of the liquid out of the filler you will be losing more and more with each set of pills you add
Option 2: take 3-5 pills into a cooker. Add water and stir stir stir. Draw up the water and either keep it in a large barrel syringe or put into a separate cooker or vial or container. Add more water to the goop in the spoon and stir stir stir, and draw up the solution and put it in the syringe/cooker/vial with the water from the first rinse. Do this for every set of 3-5 pills. The problem with this is that you will wind up with a large volume of solution as your end product. From here you can either inject as diluted as it is - but if you do this you really need to be using 0.9% NaCl solution so that the end product is isotonic and not cause any ill effects. Otherwise, you can evaporate some of the water off with LOW heat (the oxy will start to degrade if the temp gets too high) until you get the solution as concentrated as you want.

You can use a cotton filter initially, but you REALLY need to micron filter as a final step before injecting. In lieu of this, a syringe packed with sterile cotton or stacked coffee filters is the next best thing.

Now, if you're trying to make the whole script into solution but won't all be used at once, you need to take extra care to keep everything sterile, including keeping the solution in a sterile vial and using bacteriostatic water. Otherwise bacteria will grow and the solution will not be suitable for iv.

I hope that helps. If you have any other questions or want clarification just let me know.
 
^ehh id have to disagree oxy def has a rush of its own, its no heroin or dilaudid, but consider (op) that little pill only contains 5mgs of oxy, the rest are binders and fillers. IE stuff you DO NOT want in you cirulatory system. like mentioned above just take them orally. they last a LOT longer and you would have to go thru the hassle of preeping a shot that would probably fit in a 10ml syringe, straight up dangerous.
 
Seriously, it would take a ton of water to extract the oxy from 20 of those bigass pills! Just eat them, they last longer that way anyway, and the difference in B.A. is almost nil.
 
^ehh id have to disagree oxy def has a rush of its own, its no heroin or dilaudid

I was an iv oxy user for years and at the time I definitely thought it had a rush. Then I got a dope connect and when I tried to shoot oxy after having good dope it made me realize it was nothing more than instant onset/instant wellness. If I take a dose first thing in the am on a totally empty stomach, the comeup feels more euphoric than shooting it personally. I love the needle alnost as much as the drugs but with oxy it's just not worth it imo (and the rest of us here including you I suppose :) )

Also, IF you, OP use microns and a saline solution the volume doesn't much matter. But I used to get low content pills like this and shooting too much water in a non isotonic solution will make you feel like crap. So keep that in mind.
 
Thanks you all so very much... needless to say(no pun intended) lol I am so addicted to the needle...don't know why but I just am. So I've done This a hundred times but what I guess I'm worried about is This...
OK so I take 3 pills and crush and dilute and filter...the "goop" left over.... is this binders...or should I keep diluting the goop.until its all just liquid....I feel like when I use the left over shit I get migraines... anyone ever heard of this....like awful migraines And Sometimes Shaking.... I know its rediculous but I'll probly Pickup my rx and do the same tomorrow...
Thanks for all your words

Your thinking percocet not oxycodone
 
Last edited by a moderator:
If rewashing the leftovers gives you a headache, you're probably managing to get filters or bacteria in the solution. Don't let it sit out and then rewash it. And never heat it obviously. The migraine and shaking sounds like a mild case of cotton fever - are you letting it sit out and then attempting to rewash? This is really bad for you.

I like to rewash the "goop" because I always seem to get more out of it. Considering what a tiny amount of oxy is in there compared to fillers, it's hard to make sure it all gets dissolved. But I always rewash right away so nothing is growing, and use cold water so no fillers get dissolved into solution.

The "goop" should just be binders and fillers with a negligable amount of oxy left in there. I'm not sure what you mean by dilluting it until it's all liquid? The idea is to keep all the fillers as a solid so the can easily be filtered out. Another reason you could be getting migraines/shaking is because particulate got into your solution. Are you using a micron filter? Or at least filtering several times through cotton? My last idea as to the bad reaction is too much water. If I inject too much water instead of an isotonic 0.9% NaCl solution (saline) then I get those types of symptoms.
 
Honestly I don't know where to get micron filters at...so I'm gonna start using coffee filters And yes I have left it out also... what I meant by diluting it is should I take three pills crush and mix with water filter ..then the leftover stuff - should i be adding water to the left over and filtering...sorry if I'm confusing I'm trying to find the words...if I keep adding water to whatever is left over eventually it will all mix in leaving very little unfiltered. Also obviously I use a 3ml rig with a 25g screw on tip. Best of both worlds.. the head aches are most likely coming from leaving it out
 
No you don't want all the extra binders and fillers to dissolve. You add cold water and stir with a plunger from a syringe or something similar. It should leave almost all of the powder undissolved since there is only 5mg (an amount you couldn't see with your bare eyes) of oxy per pill.
 
It could be a little bit of both. So... would it be a bad idea to crush say 20 at a time and then just keep filtering 3 or 4 times then coffee filter it....ANY ideas how to do multiple shots at once without literally two veins at once? AND just a phlebotomy question- release tourniquet before plunge or after plunge?

And sorry for all my questions but your awesome so-
I have chronic pain(military) and I get like 300 of these a month for breakthrough.... what would be another opioid I could request? For iv use. Something longer lasting I'm thinking
In your opinion what's the best
 
In theory you can crush and rinse as many as your want. I just find it easier to work with small amounts since the leftover binders seem to hold onto a good portion of the water.

There's no real way to do multiple shots at once without using two iv sites simultaneously. What you can do is get a bigger barreled syringe, or evaporate off some of the extra water in the solution. This is normally what I do when prepping these pills for iv use. I typically use 10 pills - do in two groups of 5, and two rinses per group. This leaves me with a lot of water. I put it in something like a big soup spoon and with as little heat as possible, evaporate off some water. Don't let it bubble or get to a boil. I don't know off the top of my head what temp oxy begins to degrade at, and I can't swear that evaporating water won't cause a small loss of product. But it has worked fine for me. I also didn't realize what a difference saline solution makes to how I feel after a shot. This is tricky if you're going to evaporate off liquid because you don't want to boost the salinity too much. I usually use 1/2 or 1/3 saline, then the rest water, if I'm planning on evaporating water off of the solution. If you just want to shoot it without evaporating then saline is definitely the way to go.

If you are using an isotonic saline solution then in theory you can inject any amount of volume because it will not effect the salinity of your blood or mess up your electrolytes. The only issue here is a large volume of solution can be harsh on the iv site and you need to take it very slowly. And to answer your question - always release the tourniquet BEFORE shooting. You tie the tourni, find a vein, hit it and register with your rig, then release the tourni, reflag to make sure you're still in, and inject slowly and steadily.

I'm sorry to hear you have chronic pain, I go through that as well (albeit untreated at this moment). There are several other opioid available. The benefit to the oxy you are currently getting is that you're not stuck using the needle if you don't want to. The oral BA is very high so you won't be "wasting" any if you're in a situation where banging them isn't an option. Drugs like hydromorphone, oxymorphone, and morphine can all be prepped for iv (if you have IR formulations) but have very low oral BAs. Hydromorphone is notorious for the rush it provides but also the short duration. Most drugs have a short half-life when injected. Any of those would be suitable for IR breakthrough pain as well as iv use. However...I don't know if any of them will last longer than iv oxycodone though, I'm sorry. Do you take an extended release painkiller too? Hydro/oxymorphone and morphine are known for their rushes during iv, but do you really want to set yourself up so taking them as scripted is no longer an option? I would stick to the oxy so you have all other ROA available. If you are scripted so many, would your doc be willing to give you IR 15mg or 30mg tablets instead? These would be MUCH easier for iv use.

I do have to say that if you plan to continue shooting pills long term, please look into micron filters! They are available online and totally legal. You do need leur lock syringes to use with them, but ordering these would allow you to be able to get a large barrel syringe and a small gague needle since it's sounding like you have a lot of solution to inject. You can also get sterile water, saline solution, sterile vials, bacteriostatic water, etc etc etc. Check out the micron mega thread: http://www.bluelight.ru/vb/threads/481622-Micron-Filtering-Mega-Thread-and-FAQ

PS Sorry all my replies have been so long! I'm just trying to explain the best I can.
 
Last edited:
OK that sounds good I'm gonna try the saline for sure for sure..I really need to slow down when I do this...I guess i just get excited but... slow is smooth and smooth is fast:) do you have the website for the microns? I'm using a 3ml is their bigger? And if I heat To evaporate I have to make sure I let it cool down and stir it up again right?

As far as the other stuff mentioned like hydromo and morphine.. I didn't mean instead of the oxy I meant along with it for a longer acting type thing. And YES I WISH I could get 30s but the place I'm at doesn't stock them only 5mg :( and as regrettable as it is I never have been able to get my hands on dilaudid but I hear it is epic. Have you tried? Something also that may shock you a friend of mine told me that he was iv sub strips and at first I was like fuck that. But honestly its really actually not bad. Not sure if you are in US or EU buy suboxone strips about 2 or 3mg is kind of nice....no rush but a kind of speedy weird energy high....nice with morning coffee;)
 
what would be another opioid I could request? For iv use. Something longer lasting I'm thinking
In your opinion what's the best

I'm going to close this, we aren't here to tell you what to ask your doctor for, or what to take to get high. You've received sound advice from the posters in this thread, and ultimately are willing to listen to very little of it.

In the end the choices you make are yours as are the consequences, stay safe, PM if you have any questions.
 
Status
Not open for further replies.
Top