billbuilds
Bluelighter
I was wondering if it's possible to make a pre-mixed solution for IV/IM use (SAFELY)
It's a bit hard carrying a full fit pack everywhere and sometimes when your in a hurry and sometimes it's not practical. (Parents/partners in the next room).
It would also make it a bit safer for the use drugs of very high potency (fentanyl) and for a better estimation of quantity if you do not ow. High quality scales.
Say if I mixed heroin/water in a 1/10) solution ratio (1g H & 10ml water) and carried that instead of spoon & filter(cotton wool) then a 1cc syringe would hold 100mg H (or whatever strength is required).
How would I go about sterilising such a solution? My thoughts so far:
-Clean preparation equipment with bleach/isopropyl alcohol/water thoroughly and heated any metals or glass.
-Dissolving the H in a water/salt solution (what about low conc. bleach, chlorine [water purification tablets] or food preservatives [ascorbic\acetic acid])-further boiling of the sealed container (depending of breakdown temperatures of substance used)
-Also using sterile equipment (unopened syringes) would be absolutely necessary
-Well labeled storage containers (with a minor code) incase you forget the contents/inspection by LE
What are the risks involved and has anyone had any experience trying this.
Thanks
-ps - I know it woulden't last longer than a few days for H as it degrades to morphine relatively quickly. But for other drugs and "primarily" as a thought exercise
- pps - I know the risks of having unlabelled solutions/pre-prepared needles, i have had the shock after injecting (a rather strong) speedball thinking that it was plain H.
Alastair Williams
Macquarie University
It's a bit hard carrying a full fit pack everywhere and sometimes when your in a hurry and sometimes it's not practical. (Parents/partners in the next room).
It would also make it a bit safer for the use drugs of very high potency (fentanyl) and for a better estimation of quantity if you do not ow. High quality scales.
Say if I mixed heroin/water in a 1/10) solution ratio (1g H & 10ml water) and carried that instead of spoon & filter(cotton wool) then a 1cc syringe would hold 100mg H (or whatever strength is required).
How would I go about sterilising such a solution? My thoughts so far:
-Clean preparation equipment with bleach/isopropyl alcohol/water thoroughly and heated any metals or glass.
-Dissolving the H in a water/salt solution (what about low conc. bleach, chlorine [water purification tablets] or food preservatives [ascorbic\acetic acid])-further boiling of the sealed container (depending of breakdown temperatures of substance used)
-Also using sterile equipment (unopened syringes) would be absolutely necessary
-Well labeled storage containers (with a minor code) incase you forget the contents/inspection by LE
What are the risks involved and has anyone had any experience trying this.
Thanks
-ps - I know it woulden't last longer than a few days for H as it degrades to morphine relatively quickly. But for other drugs and "primarily" as a thought exercise
- pps - I know the risks of having unlabelled solutions/pre-prepared needles, i have had the shock after injecting (a rather strong) speedball thinking that it was plain H.
Alastair Williams
Macquarie University