IV Oxycodone 30 mg

[SUB SHOOTER 2010]

i have the blue 30 mg oxycodone that say K 9 on them, im iving them and would like to know the best way to do this kind

 

[chitowndown]

Grind down completely, as fine as possible, use a hose clamp. Use about 50-70 h20 in the rig( cold water) do not heat! Use micron filter if possible but if not use reg filter. Not too safe to bang up the pills, also stir well when in spoon until mostly dissolved, will be alot of filler remain when done sucking up into rig be safe brother or sister
One luv chitown

 

[chitowndown]

I've done 3 of the 30's in one shot and I got a mad rush, one will deff hit u but2-4 is the way to go, I don't know your tolerance but that's always been the ticket 4 me

 

[scottd420]

May I ask why oxycodone is your favorite drug to IV? I take it you've never tried heroin, hydromorphone or morphine intravenously, would this be true?

 

[SUB SHOOTER 2010]

i have Ived all of those things before, the rush from hydromorphine(opana) is great but the high doesnt last as long as heroin. this was the first time i had gotten any of these before. They are kinda like opana but the rush isnt as strong, lots of residue still left in the spoon, i did 2 at a time, dont see how i could fit 3, damn.

 

[Downsey]

opana is oxymorphone...and with oxycodone's rush almost nonexistent compared to morph/salts coupled with oxys high oral BA...i would just eat it.

 

[SUB SHOOTER 2010]

yeah thats right oxymorphine is opana, i like the opana 10 mg pink/red pills better than the 30 mg oxycodone. they are easier to break down too

 

[BackSeatSuicide]

i know you shouldn't heat the Oxycodone once its in hte spoon, but you should always heat the water first, and then let it cool down before adding the crushed up pill, cause it gets rid of any bacteria in the water or on the spoon

 

[effie]

^ Not true - to kill bacteria you need to heat the water to over 120 degrees C for at least 15 minutes. Even then there are certain bacterial spores which can survivie. Just heating the water a bit will do nothing, and bacteria actually reproduce faster in warm water!

You shouldn't use heat at all when prepping a pill for injecting. As you said, you especially don't want to use heat once you've added the pill - the oxycodone is water soluble in cold water, heating it just causes undesirable other bits from the pills to dissolve. To be as sterile and safe as possible you should use sterile water from sealed ampoules, and a micron filter.

This is an old thread so am going to close it - feel free to start a new thread if you have a specific question. Any queries, shoot me a pm.