I have a new connect for very high quality black tar, it's very clean, no fentanyl, practically no cut (it's been tested and is at least 70% pure) and is almost like obsidian stone, glassy rock bth. It's a beautiful thing. As I live in the east, black tar is nearly unheard of here. I will be getting some on Thursday or Friday and I want to get a general consensus on the proper technique to prep a shot. I have read a lot about it, including the iv megathread. It still seems unclear if heat is necessary or not. So far what I gather is that, any active drug (heroin, morphine, and whatever other opioids are in the less refined bth vs ecp) that is in the black tar is water soluble so heat isn't needed but may take longer to disolve in the less refined black tar as opposed to ECP/fent mixes. What I'm used to is powder that I just put in the spoon, add water, stir for a couple seconds, put in filter, draw, shoot. Can I do the same with the tar? Or is the process different?
So far what I'm thinking is this:
Boil some water on stove, put 40 to 60 mg tar chunks/powder in spoon, draw 50 or 60 units hot water into syringe, squirt over tar, stir for a bit until disolved, place filter in spoon, draw and shoot.
Or I've read that after stirring I should heat lightly again until I see some gunk(plant matter/cut?) floating and coagulating, then filter/draw up? I know that heating it can cause degradation of active opioids... I really just want to use the technique that is the cleanest and least harmful to me and my veins without destroying the drug. If I can cold shoot it with out having to wait 30 minutes for it to be dissolved (because lets face it, I just won't have the patience for that) I figure that would be the best way, as heating it could obviously also dissolve cuts and other random shit that's in it.
So what's the consensus on the correct way to prep bth shots? I'll also say that I don't and won't have wheel micron filters so I will be using cotton. I understand tgat micron filters are best, but let's just get past the fact that that will not be an option.
Thanks guys and gals. Appreciate any input
So far what I'm thinking is this:
Boil some water on stove, put 40 to 60 mg tar chunks/powder in spoon, draw 50 or 60 units hot water into syringe, squirt over tar, stir for a bit until disolved, place filter in spoon, draw and shoot.
Or I've read that after stirring I should heat lightly again until I see some gunk(plant matter/cut?) floating and coagulating, then filter/draw up? I know that heating it can cause degradation of active opioids... I really just want to use the technique that is the cleanest and least harmful to me and my veins without destroying the drug. If I can cold shoot it with out having to wait 30 minutes for it to be dissolved (because lets face it, I just won't have the patience for that) I figure that would be the best way, as heating it could obviously also dissolve cuts and other random shit that's in it.
So what's the consensus on the correct way to prep bth shots? I'll also say that I don't and won't have wheel micron filters so I will be using cotton. I understand tgat micron filters are best, but let's just get past the fact that that will not be an option.
Thanks guys and gals. Appreciate any input