Cocaine Crack resin/scrapes- How to smoke with a steamroller pipe and foil filter.

[CherryR]

How are you smoking the resin/scrapes after a sesh?

With/without ash?

Deep bowl?

UK based.

 

[CCgrl]

I get high quality crack so after 2 hits resin is already dripping down my stem. I have a thin instrument with a small slightly curved pointed end. its for scraping lobster out. Also, after taking a hit of crack, the char can be removed from the pipe and is usually caked with resin powder. Put a new piece of char in the stem and suck up a pile of resin powder, Try to use a lighter with a low flame and hold it a bit away from the pipe. Also you can hold the flame under the pipe. I just got a huge bellringer by doing this.

 

[streaM Freak]

Should work whichever way you're smoking the rock. But with foil.. it probably would drip through the holes right? Hm. That's a really good question. I wonder if you could even use tobacco instead of ash so that it stays more solid before smoking? Putting tobacco over the holes then the grease / resin might prevent it from dripping down into the pipe more than ash would. Smaller holes in the foil too maybe.

 

[ageingpartyfiend]

Should work whichever way you're smoking the rock. But with foil.. it probably would drip through the holes right? Hm. That's a really good question. I wonder if you could even use tobacco instead of ash so that it stays more solid before smoking? Putting tobacco over the holes then the grease / resin might prevent it from dripping down into the pipe more than ash would. Smaller holes in the foil too maybe.

Not good, eww. You don't want any other smoke/vapour in there apart from the feeebase, and who wants to hold a huge tobacco hit in for 15 seconds?

I also think tons of resin as an indicator for high quality product is a misconception too, moreso it indicates poor technique. You can use high quality product and have almost zero resin if you have your technique down.

 

[streaM Freak]

Yeah I agree about quality.

Well how would we prevent the grease from going down the foil holes @ageingpartyfiend

 

[ageingpartyfiend]

Yeah I agree about quality.

Well how would we prevent the grease from going down the foil holes @ageingpartyfiend

use a 'sandwich' of ash with a heavy lower 'bed', be real easy with the lighter, and draw slowly