Alright so I have been getting these little grey 100mg morphine with ABG printed on one side and 100 on the other. My methodology as of right now to get these into shootable form is just to shower the crushed pill (after removing the coating with a towel) with some cold/warm water (NOT BOILING) wait a minute, stir, and pull (preferably through a micron filter.
Now this method works pretty damn well but I can often times get 2 or 3 more decent washes out of it (nothing like the first hit but still I can feel them). I would like to be able to get my entire dose into one hit (multiple rigs is OK).
Is there any truth to what ive read that table salt will aid in this process? I have read multiple posts claiming that adding salt to the water prevents gelling (gelling is not an issue for me as I don't heat) but also aids in absorption of morphine into the water. What is the truth here? Should I add salt to my batch as I prepare it?
Now this method works pretty damn well but I can often times get 2 or 3 more decent washes out of it (nothing like the first hit but still I can feel them). I would like to be able to get my entire dose into one hit (multiple rigs is OK).
Is there any truth to what ive read that table salt will aid in this process? I have read multiple posts claiming that adding salt to the water prevents gelling (gelling is not an issue for me as I don't heat) but also aids in absorption of morphine into the water. What is the truth here? Should I add salt to my batch as I prepare it?
