I've ben using heroin for about 2 years now. Until yesterday I had only ever snorted it and occaisonally smoked it. I recently tried injecting it as snorting it was not getting me high enough. I am aware that I am embarking down a dark road now that I am starting to inject. However, I figure that if I'm going to do it, I need to be doing it as safely as possible. Here are a few questions and concerns I have after my first few experiences injecting:
1) I only have one needle at the moment, and I have used it 3 times now. I plan to get a supply of fresh ones once I find a place to obtain them. For the time being, i have been filling the syringe with isopropyl rubbing alcohol and leaving the needle/needle-cover in a small dish of the alcohol after each use. When I use it again i flush it out with water. Is this sufficient for disinfecting the needle? I am in any danger from having reused my needles so many time?
2)The last time in injected, I injected into the opposite side of the elbow on my right arm. About 10 seconds after, I began to feel very itchy and tingly between my thumb and my index finger on my right hand. It went away after about 15 minutes. Does anyone know what might have caused this? Was this potentially serious?
3)How much air in a needle is dangerous? Obviously I try to get ALL of the air out of the needle before injecting but I understand that it very difficult to get 100% of the air out everytime and that some can come in the needle when drawing back to make sure I'm in a vein. I've read that a little bit of air is ok but if anyone has knowledge on how much air until is ok until it gets dangerous that would be great.
Any help would be greatly appreciated...Thanks
1) I only have one needle at the moment, and I have used it 3 times now. I plan to get a supply of fresh ones once I find a place to obtain them. For the time being, i have been filling the syringe with isopropyl rubbing alcohol and leaving the needle/needle-cover in a small dish of the alcohol after each use. When I use it again i flush it out with water. Is this sufficient for disinfecting the needle? I am in any danger from having reused my needles so many time?
2)The last time in injected, I injected into the opposite side of the elbow on my right arm. About 10 seconds after, I began to feel very itchy and tingly between my thumb and my index finger on my right hand. It went away after about 15 minutes. Does anyone know what might have caused this? Was this potentially serious?
3)How much air in a needle is dangerous? Obviously I try to get ALL of the air out of the needle before injecting but I understand that it very difficult to get 100% of the air out everytime and that some can come in the needle when drawing back to make sure I'm in a vein. I've read that a little bit of air is ok but if anyone has knowledge on how much air until is ok until it gets dangerous that would be great.
Any help would be greatly appreciated...Thanks
