Koosh has added pics. I'm going to go through and edit out the unrelated comments later - you know the "when are the pics coming" and clean this up. I wanted to get this back up right away though. Thanks Koosh ~hfrs
How to setup and inject Amphetamine safely.
this is a guide to show you how to setup and inject amphetamine paste/base (not meth) safely.
please read this thread to find out about amphetamine.
if this is your first time on injecting i highly recommend to find much infomation on it as possible, start by viewing this step by step injecting guide and searching bluelight on injecting.
You will need the following equipment:
if you are using syringes with detachable heads then make sure you use a brand new needle for every hit.
i use a 2ml barrel but 1ml will work fine, remember use a new syringe for every hit.
make sure your spoon is sterile, always clean your spoon after each hit.
i use a cigarette filter, but you can use a cotton bud or a piece of tampon.
i use sterile water as this is the best thing for you, but you can use flat mineral water or cooled boiled water… water must be fresh and clean!
this is to dissolve your amphetamine in, this is what i use but something that can be sealed that is clean should work fine. (a spoon could work but i have never done it this way.)
i use a tourniquet as its best for the job, but items like a belt or tights will do fine.
1: use the smallest needle possible to inject. (i use 27 gauge but some people prefer a higher gauge, you choose.)
Always use new works for every hit, make sure your needle and syringes are brand new from the packet.
Now to show you how to setup:
Step 1 -
Transfer your amphetamine using the spoon to an empty baggie.
Step 2 –
Using your syringe pull up water to dissolve your amphetamine in (the more amphetamine you use the more water you will need) then push down the plunger in your baggie.
Tip: close the baggie and give it a little shake to dissolve it quicker.
Step 3 –
Now place your filter on the needle then open your baggie and start to pull the plunger back to put the amphetamine in the syringe.
Step 4 –
Now for injecting:
Step 1 -
Give your arms a wipe with alcohol wipes (what I use) or use a wet wipe, this is to prevent any bacteria infection.
Step 2 -
Place the tourniquet on the top of your arm, this is to help get your veins up.
Step 3 -
Slap your arm a couple of times to help get the veins to show (if you can’t find any veins try and use hot water as this helps too)
Step 4 -
Feel around for a vein… once found slowly place the needle in your arm, then pull back the plunger a little bit to pull blood back up, if dark blood pulls up you have hit a vein. if not try again.
note: this photo was taken with one hand. (nothing was holding the rig)
Step 5 –
Take off your tourniquet then slowly start pushing down the plunger.
All done, that was easy wasn’t it? Remember to dispose of your used works correctly.
Notice: the video will be added shortly... i need a friend to record it for me so waiting for him.