I wanted to post bcuz when i was searching. all the discussions were close to a decade old and i couldnt find any legit discussions on successfully unclogging your rig all the time.
it seriously takes 5 seconds and no bullshit. YOU NEED A TORCH LIGHTER. not a normal bic lighter as the needle will turn black and it doesnt come off easily and itll be too hard to try and hold it way lower without melting the plastic.
but just have water inside the syringe and also run some water over it and just leave your sink running.
all you have to do is quickly and when i mean quickly. like not even half a second! have the torch flame (set it near low, ya dont need a huge flame) barely touch the tip of the needle while you are pushing down on the plunger and immediately after run some water on the plastic so the heat from the metal doesnt melt the plastic and youll hear a pop and your rig will be unclogged. 1-2 tries max. 100%
hope this helps!
it seriously takes 5 seconds and no bullshit. YOU NEED A TORCH LIGHTER. not a normal bic lighter as the needle will turn black and it doesnt come off easily and itll be too hard to try and hold it way lower without melting the plastic.
but just have water inside the syringe and also run some water over it and just leave your sink running.
all you have to do is quickly and when i mean quickly. like not even half a second! have the torch flame (set it near low, ya dont need a huge flame) barely touch the tip of the needle while you are pushing down on the plunger and immediately after run some water on the plastic so the heat from the metal doesnt melt the plastic and youll hear a pop and your rig will be unclogged. 1-2 tries max. 100%
hope this helps!