RebBaron's Yopo Extraction
Here’s what’s needed:
* Acetone: available at most hardware stores. This solvent is actually present in the human body in small amounts. It’s best to use distilled acetone that you distilled yourself if you’re at all worried about contaminants. KleanStrip acetone is pure acetone and 100.0 % volatile according to their MSDS, so there will be no residue left behind after evaporating it. SWIM uses this brand, always distills it, and never finds any left over residue. It seems to be very clean.
* Pickling Lime: available at some grocery stores. It’s used to make pickles crispier. It’s not as poisonous or dangerous as the sodium hydroxide commonly used to extract DMT. Pickling lime is edible but only if greatly diluted.
* Citric acid: available as “sour salt” in some grocery stores. It’s often used in canning. It’s available from many health food or vitamin shops. This is found naturally in fruit.
* Filtering system: coffee filters aren’t that good but will work. For best filtering results it’s better to use a lab filtering system (glass micro-fiber filters, a vacuum pump, and a filtering flask, Buchner funnel, etc.)
Here's the extraction steps:
1) Prepare citric acid solution by adding 1 gram of citric acid to 10 ml of acetone. We’ll use it later so put this aside, go onto step 2, but mix the citric acid solution occasionally. It will eventually all dissolve after about an hour or so.
2) Mix 100 grams of crushed Anadenanthera seeds (either peregrina or colubrina works) with and equal volume of pickling lime (calcium hydroxide) and add enough water to form a paste. Let it sit for about 1 hour, mixing it a few times. Dry it completely in an oven at 150 F.
3) Break apart the dried materal. Add 500 ml of acetone. Mix for about 5 minutes. Let the dry material settle to the bottom. The acetone should be reddish amber in color. Pour the acetone through a good quality filter.
4) Add 10 ml of citric acid solution (from step 1) to the filtered acetone and mix. Tiny crystals will form which look like yellow dust. Let the crystals settle to the bottom. Poor off the acetone, being careful not to pour off the crystals. Discard the acetone. Wash the crystals by adding 100 ml of fresh acetone, mix, let the crystals settle, and then carefully pour off the acetone and discard it (EDIT: you might want to let the acetone evaporate down to about 50 ml before discarding, as more precipitates might form. Keep in mind that a small amount of the alkaloids won’t precipitate out of the acetone. A small portion of this contains the tiny amount of DMT present in the seeds. If you save the acetone, you could extract the last bit of alkaloids using an A/B extraction, but It’s not really worth the trouble). Let all the acetone evaporate off the crystals. They’ll start absorbing water from the air and become dark brown goo once all the acetone has evaporated.
5) Mix the crystal goo with an equal volume of pickling lime. Add enough water to form a thin watery paste. Let it sit for about 1 hour while mixing a few times. Dry in an oven at 150 F.
6) Break apart the dried material. Dissolve in 100 ml acetone for about 5 minutes, mixing a few times. Filter off the pickling time. Evaporate the acetone leaving behind 5-HO-DMT freebase as a single solid mass of amber micro-crystals (and a few other active freebase alkaloids). It looks like amber candy, not crystals. It’s very difficult to form large crystals, so don’t bother. Just scrape it up and store in an air tight container away from light.
You can repeat steps 3-6 with the same seed mix up to 4 more times to recover nearly all the alkaloids if you like, but since the seeds are so cheap, it’s probably not worth the effort.