Dante
Bluelight Crew
- Joined
- Oct 30, 2001
- Messages
- 1,266
Well, after making the best joint I've made in my life, I'm going to share the secret (blatantly stolen from www.jointen.dk but modified)...
You need:
Once the filter is made, DISREGARD any other instructions...
Step 2
Roll a paper around the joint filter, starting about halfway along the filter. You can cut the paper to fit better if you desire, but I find it's easier to just roll a whole paper around it...
And if you start halfway along the filter, when the paper is sealed, you can slide it towards the larger end of the filter to give it a very tight seal.
Step 3
Chop up your marijuana (around 1.2 grams should fill one of these), and add approximately 1/4 of your cigarette to add some filler to the mix.
Step 4
Using a piece of paper, a funnel or other equipment, pour the chopped mix into the prerolled joint paper & filter, and pack tightly with a pen or something similar.
Step 5
Once the joint has been filled and packed, twist the very end of the paper together, and push flat against the end of the joint, like so:
You could even push it flatter against the end than in that photo...
Step 6
Light it up, mofo! You'll find that this will burn very well, however, be sure to not burn the underside of the joint too much. To counteract this, turn the joint 180 degrees when passing it/having another toke
Now that I'm finished, anyone else please feel free to add their special joint tekniques...
[ 02 May 2002: Message edited by: Dante ]
You need:
- Marijuana
- 1 cigarette
- 1 pack of king-size rolling papers
- 1 piece of paper/funnel/similar equipment
Once the filter is made, DISREGARD any other instructions...
Step 2
Roll a paper around the joint filter, starting about halfway along the filter. You can cut the paper to fit better if you desire, but I find it's easier to just roll a whole paper around it...
And if you start halfway along the filter, when the paper is sealed, you can slide it towards the larger end of the filter to give it a very tight seal.
Step 3
Chop up your marijuana (around 1.2 grams should fill one of these), and add approximately 1/4 of your cigarette to add some filler to the mix.
Step 4
Using a piece of paper, a funnel or other equipment, pour the chopped mix into the prerolled joint paper & filter, and pack tightly with a pen or something similar.
Step 5
Once the joint has been filled and packed, twist the very end of the paper together, and push flat against the end of the joint, like so:
You could even push it flatter against the end than in that photo...
Step 6
Light it up, mofo! You'll find that this will burn very well, however, be sure to not burn the underside of the joint too much. To counteract this, turn the joint 180 degrees when passing it/having another toke
Now that I'm finished, anyone else please feel free to add their special joint tekniques...
[ 02 May 2002: Message edited by: Dante ]