ABadPerson
Greenlighter
- Joined
- Feb 10, 2011
- Messages
- 13
So it takes atleast 8mg of dilauded IV'd to get me my satisfactory level of high. Just wondering about these oxy's and if there's any differences in injecting oxy's compared to dilly's.
Of course i will peel the red skin off of the pill, crush with a pestle and mortar, and let the drug mix in cold water for 3-5 minutes. I'll use cotton as a filter (will be filtered twice to get as much binders/fillers as possible out).
Two questions:
1) Would injecting 60mg oxycontins follow the same procedure if i was prepping my rig for dilaudid? And if i need to inject 8mg of dilauded to feel good, how much oxy should i inject? I was very disappointed with IV'ing 4mg dilly because the rush lasted 15 minutes and after that i wasn't nodding out or anything. It was pretty weak. Just wondering if IV'ing these oxy's would be better and what would be an equivalent dosage of oxy to be prepped for IV if 8mg dilaudid is what i want.
Should i start shooting 30mg oxy, then take it from there? I've got two needles left and dunno when I'll get more so i want to make the most out of it before i go back to insufflating.
Any and all input is GREATLY appreciated. I just shot up my first time today and was unsatisfied due to my low dosage (only 4mg dilly). Seemed like a waste to put those needles into my arm just to get a 15 minute rush and then an hour long body high.
Is injecting oxy a lot weaker than injecting dilauded?
Remember: 8mg dilly IV'd is a decent dosage for me. What would be a decent dosage for oxy? My tolerance is high, i sniff 8-18mg dilly's whenever i can, and i rail an oxy 60 in two fat lines over the course of 20 mintues. I always get a great rush snorting hydro, not so much with the oxy.
Anyways now i'm being redundant, so the blunt of the question is - If i'm shooting 8mg dilly to feel good, how many mg of oxy should i shoot to feel an equal or more powerful high?
Also if anyone is experienced with injecting opioid pills like dillys and oxy's please PM me so i can be as fully informed as possible.
according to opiate conversion chart for IV it says that 20mg of oxy (IV) is == to 1.5mg hydromorphone... Does this mean i need over 100mg oxy to make the ~ of 8mg dilaudid? (Because this doesn't really make sense because when i insufflate 60mg oxy i nod the fuck out, but i need to insufflate 12-18mg of hydro no nod out.)
Of course i will peel the red skin off of the pill, crush with a pestle and mortar, and let the drug mix in cold water for 3-5 minutes. I'll use cotton as a filter (will be filtered twice to get as much binders/fillers as possible out).
Two questions:
1) Would injecting 60mg oxycontins follow the same procedure if i was prepping my rig for dilaudid? And if i need to inject 8mg of dilauded to feel good, how much oxy should i inject? I was very disappointed with IV'ing 4mg dilly because the rush lasted 15 minutes and after that i wasn't nodding out or anything. It was pretty weak. Just wondering if IV'ing these oxy's would be better and what would be an equivalent dosage of oxy to be prepped for IV if 8mg dilaudid is what i want.
Should i start shooting 30mg oxy, then take it from there? I've got two needles left and dunno when I'll get more so i want to make the most out of it before i go back to insufflating.
Any and all input is GREATLY appreciated. I just shot up my first time today and was unsatisfied due to my low dosage (only 4mg dilly). Seemed like a waste to put those needles into my arm just to get a 15 minute rush and then an hour long body high.
Is injecting oxy a lot weaker than injecting dilauded?
Remember: 8mg dilly IV'd is a decent dosage for me. What would be a decent dosage for oxy? My tolerance is high, i sniff 8-18mg dilly's whenever i can, and i rail an oxy 60 in two fat lines over the course of 20 mintues. I always get a great rush snorting hydro, not so much with the oxy.
Anyways now i'm being redundant, so the blunt of the question is - If i'm shooting 8mg dilly to feel good, how many mg of oxy should i shoot to feel an equal or more powerful high?
Also if anyone is experienced with injecting opioid pills like dillys and oxy's please PM me so i can be as fully informed as possible.
according to opiate conversion chart for IV it says that 20mg of oxy (IV) is == to 1.5mg hydromorphone... Does this mean i need over 100mg oxy to make the ~ of 8mg dilaudid? (Because this doesn't really make sense because when i insufflate 60mg oxy i nod the fuck out, but i need to insufflate 12-18mg of hydro no nod out.)
Last edited: