Part (2) Cleaning up Pills
In the procedures listed you will be able to clean up pills removing fillers, binders, flours, dyes, caffeine, speed and give your MD** a general spring clean.
This procedure provides minimal loss and gives the Raver a chance to remove some of the nasty things that you have to digest when you eat these awful illicit pills.
One pill on average contains anything from 60mG - 200mG of MD** analog. At the end of this procedure you will have destroyed the blue sonic the hedgehog esk tablet and be left with what is better known as "Molly" crystal. Far more desirable and far less candy kid. Something that you can now produce at the dinner table
IMPORTANT! BEFORE YOU START TEST YOUR PILLS AND MAKE SURE THEY CONTAIN MD**
What you need:
As far as I am aware none of the listed equipment is watched or monitored for illicit activity.
Sources - Ebay (anonomous) Lab Supply House (ideally online)
As the list below is relatively long ebay will incur lots of delivery charges. Personally I would recomend a one stop shop. Or if you want to cover your tracks divide the order into two.
Just make sure if you phone the order through and you get asked what you are doing just be ready to have an answer. There are a million reasons you would use this filtering equipment that doesnt involve cleaning up Ecstasy Pills and MDMA Powder.
For further information in regards to placing orders for clandestine purposes please refer to the following publications:
http://www.4shared.com/folder/AcHdXivg/Labs__Precursors.html
150mm Round Low Flow Filter Papers (approx price £1.50 / $2.50)
95-99% Isopropanol Alcohol OR 190 proof ethanol (approx price £4 / $6)
Anhydrous Acetone (AS DISCUSSED IN STEP 1) (approx price 500mL £4 / $6)
50mL Beaker (10mL,20mL,30mL,40mL measure marks) (approx price £4 / $6)
100mL Erlenmeyer flask (approx price £3 / $5)
Glass Filtering Funnel (approx price £4 / $6)
Glass Stir Rod (Approx 15cm - 20cm) (approx price £1.20 / $2)
Pyrex Specimen Dish (approx price £3 / $5)
90mm Petri Dish (approx price £2 / $3)
Glass Mortar & Pestle (approx price £4 / $6)
10, 15 or 20mL Long Glass Pipette (approx price £2 / $3)
200mm Lab Spatula (approx price £4 / $6)
Aluminium Foil (Raid your kitchen)
Paper Towels (Raid your kitchen)
Single Stanley Blade (30p / 50c)
Section 1 (Removing Caffeine, Binder, Filler, Dye, Adulterant that dissolve in Acetone & MD crystal seperation)
Important Note: If your beaker full of acetone is not having a process conducted on it then make sure it is covered by the aluminium foil at all times. This is to prevent evaporation and also water from entering the acetone from the air. If water enters the acetone it will dissolve product.
(1.) Using your glass Mortar & Pestle crush up the relevant MD** pill. Crush the pills nicely into powder. Make sure this powder is crushed as fine as possible.
(2.)
First fill your beaker with 20mL of Anhydrous Acetone using the Glass Pipette. Pour the crushed pill powder into the Acetone
(dont put the powder in first before the acetone). Stir for a few minutes using your Glass Stir Rod.
(3.) Cover the lid of the beaker with your Aluminium Foil (to prevent evaporation) and leave to settle. Once settled you will see a bottom layer has formed of MD** Crystals mixed with any other cuts/adulterants etc that arent soluble in acetone. All the additional crap in the pill has now dissolved and has dissolved in the clear acetone liquid at the top (when I say clear I mean nothing floating around in it) (it may well have a colour this is okay). This is now the "poluted acetone" that we want to get rid of.
(4.) Place your Glass Funnel into the top of your Erlenmeyer flask. Put a round filter paper into the top of your glass funnel. The purpose for this is to prevent any waste of product.
Carefully pour off the clear layer of acetone into your Filter setup stopping before you empty out any wanted product. If for any reason some good product goes in the filter this is okay because you are filtering as a safety precaution. Once you have successfully removed the clear layer of acetone you should now have a mixture of MD** crystal + non dissolved adulterants left at the bottom of the beaker.
(5.) Squirt another pipettes worth (approx 10mL) of Anhydrous Acetone into your beaker with the product in it and stir again. Once again Aluminium Foil the top of the beaker to prevent evaporation and let it settle. This time look carfully at the resedue at the bottom. There should be MDMA crystals at the bottom and above a layer of pill resedue. On next pour this time you want to get rid of the clear acetone and also this resedue above the MD** crystals.
keep repeating this procedure until you have got rid of all the resedue and are just left with the magic crystals.
(6.) Remove the filter paper and put to one side to dry. This filter paper may have a small amount of product in it so
save it till later. You can pick out the crystals once its dried if required.
(7.) Put a fresh filter paper in your Glass Funnel. Using your pipette squirt just enough acetone into the beaker with the product still in it. Quickly swish the product around. Now pour the entire contents into the fresh filter setup. Do another squirt with the pipette into the beaker get any remaining crystal resedue out and pour into the filter with the rest of the crystal. For a final rinse get a pipette full of fresh acetone and squirt over all the crystals. Cover the top now with Aluminium Foil whilst the acetone
fully drains through the product. Allow it time to drain properly.
(8.)
Carefully remove the filter paper and fold it in half onto the crystals applying pressure to squeeze out as much remaining acetone into the flask. Next place the folded filter paper with the crystals inside into your pyrex specimen dish. Get your hair dryer onto hot and whilst the crystals are still folded in the filter blow dry for approx 5 minutes.
Hold the filter whilst blow drying or it might blow away.
(9.) Open up the filter and place it on a paper towel. The plan now is to remove any excess acetone. Use another paper towel to dab the crystals trying to dry out as much as possible.
Once you are happy the crystals are as dry as you can get them
Carefully tip and scrape the dried crystals off the filter paper using your spatula and stanley blade blade into your Petri Dish.
Some prefer to leave the crystals in the paper during the drying process. This is something you will have to experiment with.
(10.) Leave the crystals for a minimum of 48 hours to fully dry out. If they still reak of acetone leave for a while longer. Some suggest having them under a lamp may help but Futura thinks this is a waste of electricity and is likely unnecessary.
Technique for extracting the crystals from the original waste filter
(1) Take the original filter paper containing mostly cuts along with the few MDMA crystals that fell thru with the original pours and crush the mixture up thoroughly.
(2) Pour the entire contents onto one side of a wax coated paper plate. Take the plate in your hands and tilt it slightly towards you with the pile at the top. From underneath, gently tap on the pile and the crystals will pop out of and fall directly down the plate towards you. Stop tapping when the powder starts to fall with the crystals.
(3) Using your stanley blade or spatula gather the crystals and put them on a seperate plate. Push the entire pile back to the top and keep repeating this tedious process for about 10-15 minutes until every last crystal has been seperated. Once complete discard the old filter your mission is complete.
Technique for extracting product from the waste Acetone
(1) Empty dirty Acetone into your Pyrex Dish
(2) Leave to evaporate
(3) Using spatula scrape product into beaker
(4) Perform mini acetone wash
(5) Dry / empty in petri dish / Dry some more
(6) Follow steps above with paper plate to extract MDMA crystals
Section 1 (Removing amphetamine + more adulterants)
Low Flow Filter papers
Isopropanol Alcohol
Home Depot Acetone
50mL Beaker
100mL Erlenmeyer flask
Glass Filtering Funnel
(Get one that doesnt have such a long tube as this)
Glass Stir Rod
Pyrex Specimen Dish
90mm Petri Dish
Glass Mortar & Pestle
20mL Long Glass Pipette
200mm Lab Spatula
The Filtration Process