crescentry
Bluelighter
- Joined
- Oct 8, 2018
- Messages
- 27
Hi! Not sure where to put this thread so I just put it here because I'm possibly putting hash oil in it. I was thinking of a way to make some sort of herbal blend, but I didn't know if it would work the way I think it will, so here goes:
A base of some sort of herbs, dried and finely crumbled
A powdered extract of some sort ( I would use a 10x wild dagga extract (
A little bit of corn starch to keep it all together
Distilled water
So you take your dry ingredients and mix them together, making sure there's not too much powder in there just in case the cornstarch doesn't take.
Move the ingredients to a graduated cylinder or something with tall sides
Put just enough water to soak the mixture
Press the mixture into a block or a thin sheet, saving the water that comes out
Let it dry by evaporation (no heat applied)
After drying take the water and slowly dribble it onto the blend over time, allowing the runoff from the pressing stage to soak in
I'm actually not sure how a cannabis extract would go in there because after writing this I realized the water would probably carry it away after pressing into a brick, so it might be better to just use kief.
So anyway, you basically just crumble this up and smoke it. Any advice on improving this before I try and possibly fail would be very welcome.
A base of some sort of herbs, dried and finely crumbled
A powdered extract of some sort ( I would use a 10x wild dagga extract (
A little bit of corn starch to keep it all together
Distilled water
So you take your dry ingredients and mix them together, making sure there's not too much powder in there just in case the cornstarch doesn't take.
Move the ingredients to a graduated cylinder or something with tall sides
Put just enough water to soak the mixture
Press the mixture into a block or a thin sheet, saving the water that comes out
Let it dry by evaporation (no heat applied)
After drying take the water and slowly dribble it onto the blend over time, allowing the runoff from the pressing stage to soak in
I'm actually not sure how a cannabis extract would go in there because after writing this I realized the water would probably carry it away after pressing into a brick, so it might be better to just use kief.
So anyway, you basically just crumble this up and smoke it. Any advice on improving this before I try and possibly fail would be very welcome.