Hi guys, long time!
Anyway, I am messing around with that black tar again and have run into an issue.
Years of IV drug use have left my arms a wreck, as far as finding veins. I have looked at my feet but never found anything other than a one-off lucky shot. I am fine with getting less of a rush for another less harmful MOA. Thing is, I also need the bioavalability to be high. The heroin induced constipation knocks out plugging _most_ of the time as my rock turds absorb the heroin solution (I think) when my colon is stuff to the brim with brown concrete. If I can manage to give birth to a pineapple out of my ass beforehand the plugging works a lot better. Skin popping and IM are kinda out of the questions right now because it is actually more unsafe than IVing from an abscess perspective. Even if I do find a new vein, it doesn't last long with this dope. I need a new plan.
If you couldn't IV IM or SC, what would you use to get the most out of your tar? All I want to do is use it without wasting it. Even sniffing the water hurts my sinuses. The only thing that doesn't hurt is plugging and smoking.
So, I firmly beilive my dope is more acidic than it needs be. It stings like a motherfucker going in and that contributed largely to my veins shrinking up and going away. Even veins that used to be juicy, where I always used a fresh rig and never missed; resulted in the vein getting thinner and thinner until it was almost gone. If I miss, there is a hard lump of what I assume is scar tissue under the skin. This lump is much smaller to non existent if I do the following.
I have experimented with putting some baking soda in my spoon to balance out the PH. If I used a VERY VERY small amount (the amount balanced on half an inch of a toothpick), everything seems to work good. I know one thing, the shot burns 100x less. I am afraid I am turning my heroin HCL into heroin freebase and making it not soluble in water though, thereby wasting dope. Is this a wise way to lower the acidity? How can I make sure I don't lower it took much and start to waste dope?
One time I added too much baking soda and the solution went from dark black to light brown. Black rubbery chunks floated atop. These chunks were very gummy and very small. Enough to cover the plunger end where your thumb goes. I suspected this was freebase and tasted it. It tasted of nothing. The solution tasted of nothing. Well, not nothing, but not the tell-tale hallmark opioid taste.
So how can I make sure my shots are only as acidic as they need be and not as acidic as vinegar? I am tired of mutilating my arms because opiates are too expensive.
Thanks guys!
Anyway, I am messing around with that black tar again and have run into an issue.
Years of IV drug use have left my arms a wreck, as far as finding veins. I have looked at my feet but never found anything other than a one-off lucky shot. I am fine with getting less of a rush for another less harmful MOA. Thing is, I also need the bioavalability to be high. The heroin induced constipation knocks out plugging _most_ of the time as my rock turds absorb the heroin solution (I think) when my colon is stuff to the brim with brown concrete. If I can manage to give birth to a pineapple out of my ass beforehand the plugging works a lot better. Skin popping and IM are kinda out of the questions right now because it is actually more unsafe than IVing from an abscess perspective. Even if I do find a new vein, it doesn't last long with this dope. I need a new plan.
If you couldn't IV IM or SC, what would you use to get the most out of your tar? All I want to do is use it without wasting it. Even sniffing the water hurts my sinuses. The only thing that doesn't hurt is plugging and smoking.
So, I firmly beilive my dope is more acidic than it needs be. It stings like a motherfucker going in and that contributed largely to my veins shrinking up and going away. Even veins that used to be juicy, where I always used a fresh rig and never missed; resulted in the vein getting thinner and thinner until it was almost gone. If I miss, there is a hard lump of what I assume is scar tissue under the skin. This lump is much smaller to non existent if I do the following.
I have experimented with putting some baking soda in my spoon to balance out the PH. If I used a VERY VERY small amount (the amount balanced on half an inch of a toothpick), everything seems to work good. I know one thing, the shot burns 100x less. I am afraid I am turning my heroin HCL into heroin freebase and making it not soluble in water though, thereby wasting dope. Is this a wise way to lower the acidity? How can I make sure I don't lower it took much and start to waste dope?
One time I added too much baking soda and the solution went from dark black to light brown. Black rubbery chunks floated atop. These chunks were very gummy and very small. Enough to cover the plunger end where your thumb goes. I suspected this was freebase and tasted it. It tasted of nothing. The solution tasted of nothing. Well, not nothing, but not the tell-tale hallmark opioid taste.
So how can I make sure my shots are only as acidic as they need be and not as acidic as vinegar? I am tired of mutilating my arms because opiates are too expensive.
Thanks guys!
Last edited: