Usirius1
Bluelighter
- Joined
- May 1, 2012
- Messages
- 96
So, i have tried searching for anyone else's suggestions on this, but have not had a lot of luck. Let's say that you happen to have a rather small plastic baggy with 10mg of an LSD analogue in powdered form, how would you go about getting all of that powder into a vial of liquid with minimal loss of substance?
My idea was to careful pipe some of the solvent into the baggy to dissolve it into solution while in the baggy and then pipe that into a vial, and then repeat with pure pure solvent repeatedly until the volume of solution in the vial equals the intended volume. however this method will still end up with some solution remaining on the inside of the baggy.
Does anyone else have a better idea?
My idea was to careful pipe some of the solvent into the baggy to dissolve it into solution while in the baggy and then pipe that into a vial, and then repeat with pure pure solvent repeatedly until the volume of solution in the vial equals the intended volume. however this method will still end up with some solution remaining on the inside of the baggy.
Does anyone else have a better idea?