Sublimit
Bluelighter
- Joined
- May 21, 2009
- Messages
- 408
Hey guys and gals, I'll get to the point and would like some experience with this as this has never happened to me before.
I was IVíng 80mg of oxycontin, 8 10mg pills swabbed and finely crushed, filtered twice, loaded into a 10ml barrel and .22micron filtered into 8ml of water. I got about half way and felt a slight sting so i tried to register again but couldn't get it so i loosened my belt and pulled out the 25 gauge needle, swabbed again, put the belt back on and went for another vein on the same arm. by this time there was a lot of blood in the barrel and i registered but it felt wrong so i pulled it out again....
this was about 3mins of there being blood in my barrel so i was worried about it clotting. when i went to try a 3rd time i just checked to see if i could push a bit of solution out and aimed it at the floor... i applied a fair bit of pressure until a tiny bit just busted out everywhere8)
so i replaced it with a new 25 gauge tip and went again as it was about 4ml left and full of blood. I wondered why it was blocked and when i did the exchange of tips the used one had like a blood looking worm hanging from it??? i thought WTF? and put my 2 fingers and pulled it out.
thats the best way to describe it. it was about an inch long and blood red and about as thick as the lead in a pencil. i held it with my fingers and rolled it around and it sort of just turned into blood when i put it on the floor and pressed it, seemed a bit rubbery??? but then just seemed to turn into blood when i pressed it on my wooden floor.
I have a lump on my arm that is settling down about 45mins after the shot but i can still feel a hardish lump there on my arm. I don't want to flex my arm to see if i can see the vein as i don't want to damage it anymore. It didn't really hurt, and feels a bit uncomfortable now, but what the fuck?
I'm into harm reduction and have never IV''d pills without using a micron, and never had collapsed a vein through my H using days and always rotated..... but did i just suck a bit of my vein out of my arm? I wasn't drawing back hard, but i'm not really used to using a 10ml barrel either.
If that was the case would it be possible to actually suck a part of your vein into a needle? and would it turn to blood when pressed? I've never had this happen and a part of me thinks that it was just my blood clotting at the tip... but when i pulled it out it felt elastic and looked like a small worm.
I know it's a lot to read but i'd appreciate if anyone could put my mind at ease. the lump is still there and it looks like i'm missing a part of my vein
EDIT; i tightened my arm and it looks as if the vein runs through the length of my bicep, with no gap.... i guess i'll know more when the lump dies down, but it's freaking me out a bit still. I got an errand and i hope to see some mind settling reply's.... i hope...
I was IVíng 80mg of oxycontin, 8 10mg pills swabbed and finely crushed, filtered twice, loaded into a 10ml barrel and .22micron filtered into 8ml of water. I got about half way and felt a slight sting so i tried to register again but couldn't get it so i loosened my belt and pulled out the 25 gauge needle, swabbed again, put the belt back on and went for another vein on the same arm. by this time there was a lot of blood in the barrel and i registered but it felt wrong so i pulled it out again....
this was about 3mins of there being blood in my barrel so i was worried about it clotting. when i went to try a 3rd time i just checked to see if i could push a bit of solution out and aimed it at the floor... i applied a fair bit of pressure until a tiny bit just busted out everywhere8)
so i replaced it with a new 25 gauge tip and went again as it was about 4ml left and full of blood. I wondered why it was blocked and when i did the exchange of tips the used one had like a blood looking worm hanging from it??? i thought WTF? and put my 2 fingers and pulled it out.
thats the best way to describe it. it was about an inch long and blood red and about as thick as the lead in a pencil. i held it with my fingers and rolled it around and it sort of just turned into blood when i put it on the floor and pressed it, seemed a bit rubbery??? but then just seemed to turn into blood when i pressed it on my wooden floor.
I have a lump on my arm that is settling down about 45mins after the shot but i can still feel a hardish lump there on my arm. I don't want to flex my arm to see if i can see the vein as i don't want to damage it anymore. It didn't really hurt, and feels a bit uncomfortable now, but what the fuck?
I'm into harm reduction and have never IV''d pills without using a micron, and never had collapsed a vein through my H using days and always rotated..... but did i just suck a bit of my vein out of my arm? I wasn't drawing back hard, but i'm not really used to using a 10ml barrel either.
If that was the case would it be possible to actually suck a part of your vein into a needle? and would it turn to blood when pressed? I've never had this happen and a part of me thinks that it was just my blood clotting at the tip... but when i pulled it out it felt elastic and looked like a small worm.
I know it's a lot to read but i'd appreciate if anyone could put my mind at ease. the lump is still there and it looks like i'm missing a part of my vein
EDIT; i tightened my arm and it looks as if the vein runs through the length of my bicep, with no gap.... i guess i'll know more when the lump dies down, but it's freaking me out a bit still. I got an errand and i hope to see some mind settling reply's.... i hope...
Last edited: