curioushat
Bluelighter
- Joined
- Feb 28, 2011
- Messages
- 150
I am absolutely desperate to learn how to chase the dragon properly. So far it has been an epic fail and I am tired of wasting good #3 powder.
Has anyone ever seen a video demonstrating how to do it? Especially starting from powder. Thanks. I don't have a coach unfortunately and the next best thing would be to see it in action. It would answer so many of my questions.
Also, I have some questions if there is no video since I have researched forever and cannot find answers to little nuances.
If you can answer any of the questions, your response is appreciated!!
I know this is a crapload of questions. If you can answer any of them that is greatly appreciated. Thank you so much in advance! I have searched a million guides and none seem to answer these specific questions!
Has anyone ever seen a video demonstrating how to do it? Especially starting from powder. Thanks. I don't have a coach unfortunately and the next best thing would be to see it in action. It would answer so many of my questions.
Also, I have some questions if there is no video since I have researched forever and cannot find answers to little nuances.
If you can answer any of the questions, your response is appreciated!!
Code:
[U]1.[/U] When you lay out the powder, do you try to make it as close to a mound as possible? Or is it better as a line?
Code:
[U]2.[/U] When you turn the powder into the stick black, do you want a perfect hemisphere/blob (or close to it)? Or should you put it in a line and go back and forth? Is it a problem that the blob is flat?
Code:
[U]3.[/U] Does it make a difference how finely crushed the number three is to start off?
Code:
[U]4.[/U] If when you are done it leaves behind a black ashy substance is that a cut? Or is it burned and therefore wasted heroin?
Code:
[U]5.[/U] I know that it is important to make sure the blob is moving around. How do you keep it in a blob and not have it spread out?
Code:
[U]6.[/U] Should you fold the foil in half to make a crease? And then make the substance rock back and forth?
Code:
[U]7.[/U] Why is it that sometimes no matter how long I hold the flame over a blob it sometimes never moves or vapes?
Code:
[U]8.[/U] Are having multiple "strongholds" of melted heroin a no-no? It seems like it's impossible to vaporize them one at a time.
Code:
[U]9.[/U] Is it a huge problem that the foil might be a little crumbled?
Code:
[U]10.[/U] If there are just two shiny sides of the foil , does it matter which is used as the surface?
Code:
[U]11.[/U] What is a [I]rough[/I] range of heroin that should be put on foil at once? I'm sure any small amount is fine, but is, say, 100mg at once a total waste?
I know this is a crapload of questions. If you can answer any of them that is greatly appreciated. Thank you so much in advance! I have searched a million guides and none seem to answer these specific questions!
Last edited: