• 💊 OTHER DRUGS 💊 Welcome Guest
    Posting Rules Bluelight Rules
    Notable Threads 1 Notable Threads 2
    Dangerous Combos Addiction Support
    Emergency Services Benzo Guide v.1
    Addiction Stories Scary Case Studies
    Biology, Pharmacology & Drugs 101
  • Select Your Topic Then Scroll Down
    Alcohol Bupe Benzos
    Cocaine Heroin Opioids
    RCs Stimulants Misc
    Harm Reduction All Topics Gabapentinoids
    Tired of your habit? Struggling to cope?
    Want to regain control or get sober?
    Visit our Recovery Support Forums

Opioids Plugging morphine sulfate IR (Statex) questions...

M

MAIKU

Greenlighter
Joined
May 7, 2015
Messages
5
Hey all,


Got a decent batch of 10mg Statex IR pills (morphine sulfate IR in Canada) and I have finally decided to try plugging them after going to oral route for a while. Planning to start very low at 20mg for now, which is two pills. I crushed them to fine powder and mixed it with water (boiled then cooled down a bit). Is there any need to filter this solution for safety reasons when plugging? Or is it fine as is?


Also, the powder don't seem to mix very well to the water, the powder seems to constantly settle down separated from the water when not mixed for a while... Is this a abuse prevention mechanism or just that the pill is not that soluble? Would this be ok to plug?


Thanks in advance.
 
Hey Maiku and welcome to Bluelight,

as far as I know it is not necessary to filter the solution you want to plug. The morphine will be absorbed and the fillers will just be excreted normally.

Z
 
It's probably the filler settling.probably only ten percent of the pill is active content at best.
 
You must log in or register to reply here.
Top