PaducahManDingo
Greenlighter
- Joined
- Apr 6, 2020
- Messages
- 3
I just got a script for 15mg Mallinkrodt "M-Box" 15s from my pharmacy. I've been crushing and snorting all of them for years. Over the past few months when I get close to the end of the script I notice when I crush one it turns into this "pasty/wet" material that can't be cut with a blade properly without the pasty new product sticking to the blade. To be on the safe side I bought a new crusher, new blades, am using a new straw and a new surface just to be sure none of them were wet - and that isn't the case (or I wouldn't be here lol).
I usually sit on my comode with a wooden shelf across my lap, put a small square plate on it, cut one of these 15s in half, put both halves into my arthritis friendly crusher (it's not a grinder it's an actual two part crusher), crush the pill and it makes a "smash" sound. Then I partially unscrew the crusher, shake it a bit to redistribute the powder then crush again. I repeat this until I'm satisfied with the "sound" and "feeling" which I know when is right for my taste. Then I dump about half the powder into evenly distributed lines on the aforementioned square plate. I use a paint scraping blade to cut this very dry powder into very fine, near powdered sugar quality lines then snort it through a pen straw, being sure the powder is evenly distributed between my nostrils and only hard enough so it stays on the membrane and not into my throat. I gauge my success based on how I feel about 3 to 5 minutes later then do the other half. I do this over and over until in experiencing the desired effect, which is honestly just general pain relief in my case.
I can do about the first 90% of the script this way very successfully and without them becoming pasty as mentioned above. But why does the last 10% always seem to become all nasty and unusable? Thanks in advance for your answers and suggestions!
I usually sit on my comode with a wooden shelf across my lap, put a small square plate on it, cut one of these 15s in half, put both halves into my arthritis friendly crusher (it's not a grinder it's an actual two part crusher), crush the pill and it makes a "smash" sound. Then I partially unscrew the crusher, shake it a bit to redistribute the powder then crush again. I repeat this until I'm satisfied with the "sound" and "feeling" which I know when is right for my taste. Then I dump about half the powder into evenly distributed lines on the aforementioned square plate. I use a paint scraping blade to cut this very dry powder into very fine, near powdered sugar quality lines then snort it through a pen straw, being sure the powder is evenly distributed between my nostrils and only hard enough so it stays on the membrane and not into my throat. I gauge my success based on how I feel about 3 to 5 minutes later then do the other half. I do this over and over until in experiencing the desired effect, which is honestly just general pain relief in my case.
I can do about the first 90% of the script this way very successfully and without them becoming pasty as mentioned above. But why does the last 10% always seem to become all nasty and unusable? Thanks in advance for your answers and suggestions!