IV preparation of MS Contin (mallinkrodt)
Okay, I've been a lurker on bluelight and opiophile for the past few months (pretty much when i started IVing, and I've been really bothered by the methods of preparing MS Contin (and TEEVA oxycodone ER or any other "gelly" pills) shots that have been suggested.
Here is my method...
What you will need:
-Mallinkrodt MS Contin (or the ABG kind or any other kind of pill that may gel up, I use the 30mg and 100mg tablets)
-A piece of glossy paper (i've been using the manual that came with my nintendo DS, lol)
-1cc insulin syringes, 31 guage (all that is available here in KS)
-A table spoon (i like measuring spoons cuz they're thin and and i don't have to worry about spilling my shit)
-Cigarette filter or wheel barrel filter (i have never seen a wheel filter in my life, cigarette filters work fine for me)
-water (kansas swamp/tap water works great...)
-electric range stove, the coil kind (because it doesn't leave all that carbon black all over my kit)
1 - Remove the coating of the pill with a damp napkin or tissue
2 - fold the piece of glossy paper and put the pill in the fold of the paper and crush with a lighter (i've found that rolling the paper back and forth like a joint gets the powdered pill to come unstuck from the paper). You should be left with a paper chute with finely crushed pill in it.
3 - turn your electric range on to about "6" or "7"
4 - add about 1.8 cc of water to the spoon (without adding the powder yet), set it on the burner and wait for it to begin boiling
Step end of the needle so you'll be ready to draw up the solution, because you need to draw it up fast
6 - just as the water starts boiling, drop the powder in with your paper chute you made
7 - let it boil for about 3 or 4 seconds, stir it once or twice with the plunger of the syringe and let it boil for another couple seconds
8 - draw the solution up as quickly and efficiently as possible. if you do everything right you should end up with a minimal ammount of gel at the bottom of the spoon. if you do end up with gel, don't freak out. you're going to need to add a little less than a CC, maybe less and boil it with the gel for a few seconds, as long as it takes to get the water kinda cloudy again. push the gel that's left to the edge of the spoon and draw up the solution with a clean filter (meaning... just leave the cotton you used before in the spoon with the gel and ignore it and use a clean cotton because if you get the syringe in the gel, you can clog it really easily)
9 - if you're lucky and quick and patient, this should leave you with a cloudy, off-white looking solution in the syringe. whatever gel is left in the spoon DOES CONTAIN DRUGS, and therefore you should save it till when you run out (i scrape all mine and stick it on the inside of a jar that i keep). just take the gel from maybe 7 or 8 pill you've done and boil the fuck out of it, push the gel to the side, and draw up the solution. i've got shots from doing this that were easily 200mg and gave me pins and needles in my head like you wouldn't believe. good if you have a couple of days wait for whoever's script to get filled.
10 - ??????
11 - Profit!
And that, ladies and gentlemen, is how I've been kickin' it for the past 5 months