Heroin number 3 heroin,

[kkgb1035]

how should i go about using number 3 heroin? if i was to use distilled vinger what the ratio of how much i should add if i were to shoot .1.
also can #3 be just as strong #4?

 

[Elilrac]

As little as u need to is best. Just add 10 units at a time until it is a) completely dissolved b) no more reaction is taking place (bubbles/fizzing)

 

[Elilrac]

Then fill the rest of the rig with water to dilute the solution.

 

[bingey]

N 3 is usually cut with caffeine. The only (practically) pure heroin in circulation is Asian no 4. That being said it's not uncommon for no 4 to be more adulterated than no 3 especially with active cuts (yuck)

 

[Psychedelic Jay]

All you need to do to clean up no.3 before you get ready to use it is...:


1. If it is compressed, crush it as fine as possible, put it in a coffee filter and run room temp water over it, and dry it under a lamp...
2. If it is a powder, do the exact same thing...

This will wash the caffeine off of it and leave cleaner freebase so you can make your salt. (acetate, citrate, hydrochloride)

 

[bwanajzj]

Video of heroin no. 3 being dissolved using acid - title: "how much citric?". It is made by the producers of the citric acid sachets found in most needle exchanges in the UK and Europe.

Do you not have access to sterile citric acid in powder form? If so, assuming H is pure, a 1:10 ratio of acid:heroin should suffice. Since H is rarely pure, use less acid or titrate until it is dissolved. But adding too much acid can cause adulterants to be dissolved, it can destroy the heroin molecule and it can cause serious vein damage, etc. So use as little as possible. If you use above posters method, and then add acid, you will avoid the caffeine cut and will also be able to better come close to the aforementioned ratio, so that your solution does not become too acidic. However, it is very difficult to say how much you need to add, as we have no idea what is in your H no. 3.

 

[bwanajzj]

A while back I posted the following thread:

What is the optimal pH for heroin no 3 dissolution?

amapola and others came up with good feedback, but we never came to a consensus about the optimal pH or the right amount of acid and so on. Best is to titrate until all is dissolved, maxing out at the above mentioned 1:10 ratio, and not let your eyes fool you when gunk is still floating around, as there is usually so much crap mixed into brown heroin (heroin no. 3). Since posting above thread, I have done a lot more shots of heroin, and found that very little acid is needed to dissolve average street heroin no. 3. I used waaaaaay too much acid in the beginning.