stuffmonger
Bluelighter
- Joined
- Oct 21, 2010
- Messages
- 220
Hello Everyone. I've been lurking here for years and just recently decided to join up. I'm hoping to get some help here.
I'm a huge fan of MDPV. Not the white hydrochloride - it's inconceivable that anyone on the planet would willingly put that into their bodies -- I'm talking the freebase form. I think many of you that don't bother to freebase it yourself have at least tasted the freebase version when it was widely available as "tan mdpv". I think it's the finest drug evere conceived, not just for the indescribable hypersexuality, but also for the smooth euphoria and mild comedown.
My question is this: How can I more easilly separate the oil from the precipitate using some mechanical means?
Here's the nightmarish process I've been going through so far:
First I precipitate and then place the container on a foot vibrator for 30 minutes to raise the first oil (the oil is heavier than water, by the way):
Then I painstakingly touch each droplet with the point of a hyperdermic, which causes the oil to climb up the needle. Then I slowly extract the needle until the surface tension at the top allows the oil to float.
I can only do a small amount at a time or else the oil collects into a ball large enough to sink again. I draw off the oil with a filed down needle point and then spend another 30 mitues of vibrating until the next batch rises. As I proceed, the droplets become smaller and smaller until they are barely visible. The complete extraction takes 5 to 6 hours.
For anyone who freebases mdpv, by the way -- the oil is dangerous beyond belief. When I first started doing this I accidently got a few drops on my fingers while handling a used flask and didn't sleep for 4 days. I had visual and auditory hallucinations and the worst paranoia of my life. It's all the bad aspects of white mdpv times a hundred. If you think the comedown from the white mdpv is bad, rub this oil into your skin. You'll be begging for a hundred milligram dose of the white in exchange. Use rubber gloves.
Anyway --- can someone tell me how I can mechanically separate the oil from the precipitate in less than 5 hours? I definitaely don't want to use a reagent. I'm not a chemist or any kind of scientist by the way, just someone who refused to accept the "new mdpv".
Thank you.
I'm a huge fan of MDPV. Not the white hydrochloride - it's inconceivable that anyone on the planet would willingly put that into their bodies -- I'm talking the freebase form. I think many of you that don't bother to freebase it yourself have at least tasted the freebase version when it was widely available as "tan mdpv". I think it's the finest drug evere conceived, not just for the indescribable hypersexuality, but also for the smooth euphoria and mild comedown.
My question is this: How can I more easilly separate the oil from the precipitate using some mechanical means?
Here's the nightmarish process I've been going through so far:
First I precipitate and then place the container on a foot vibrator for 30 minutes to raise the first oil (the oil is heavier than water, by the way):
Then I painstakingly touch each droplet with the point of a hyperdermic, which causes the oil to climb up the needle. Then I slowly extract the needle until the surface tension at the top allows the oil to float.
I can only do a small amount at a time or else the oil collects into a ball large enough to sink again. I draw off the oil with a filed down needle point and then spend another 30 mitues of vibrating until the next batch rises. As I proceed, the droplets become smaller and smaller until they are barely visible. The complete extraction takes 5 to 6 hours.
For anyone who freebases mdpv, by the way -- the oil is dangerous beyond belief. When I first started doing this I accidently got a few drops on my fingers while handling a used flask and didn't sleep for 4 days. I had visual and auditory hallucinations and the worst paranoia of my life. It's all the bad aspects of white mdpv times a hundred. If you think the comedown from the white mdpv is bad, rub this oil into your skin. You'll be begging for a hundred milligram dose of the white in exchange. Use rubber gloves.
Anyway --- can someone tell me how I can mechanically separate the oil from the precipitate in less than 5 hours? I definitaely don't want to use a reagent. I'm not a chemist or any kind of scientist by the way, just someone who refused to accept the "new mdpv".
Thank you.
Last edited:
