Stimulants Filtering Ritalin - little effect

[adrenalin1999]

Hey All,

I have blasted Ritalin several times, filtered through a red 1.2 micron filter and it has had little effect.

Last time I mixed 3 normal release 10mg pills in approx 7ml of hot water (not boiling but hot) mixing directly in the barrel I shook it for a few minutes, let it sit and shook it well again, with the plunger almost out so there was an air pocket for the mixture to shake in.

I could only get about 5ml's out through the filter but that seems like an acceptable loss due to fillers etc adding to the volume of the original mix. I took a lot of pressure to push through the filter as I didnt pre cotton filter as i have other times.

On shooting it there was no real hit. Am I not breaking the MPH out of the binders and they are all being filtered out together?

Btw I wont shoot any poills not micron filtered but id like the hit ive heard about from it.

Thanks

 

[NeighborhoodThreat]

Hey adrenalin1999, welcome to Bluelight! Hope you find the information you're looking for and lots more

In regards to your question, you're right to use a micron filter before IVing pills. However, I don't exactly understand what you mean by "not breaking the MPH out of the binders". When you crush up the regular release Ritalin pills you're putting all resulting powder in the water, before filtering it through the micron filter, correct?

To be honest, I'm not very experienced with IVing pills (oral/snorting are my ROAs of choice), but somebody else on this board will be able to help sooner or later, perhaps not tonight as it is St. Patrick's Day!

In the meantime, I recommend you take a look at the Micron Filtering Mega Thread and FAQ, it has lots of information about micron filter use and IV practices in general