RCs Etizolam Powder - how to ingest

[JimJim]

Hi,

I've been taking etizolam for the past three years. I have a high tolerance and can get through a strip of 10 1mg tablets in a day easily (usually in 2x5 tabs at a time)… this has started to become very costly so I have bought my first bag of powder.

I am wondering how is best to take this and would appreciate any feedback, comments and experiences.

My plan - weigh out a dose of 10mg (0.1 on my scales) then split that in to 2-3 very small bumps and just dab my finger, lick it and then wash down with water. I have read in other posts about making a solution with alcohol etc but I am not sure i'd be any good at this so firstly.. will my plan work as a viable route of administration for etizolam? Secondly if it will not work I would appreciate any feedback on alternatives. My mate says 'just sniff it' but i have read contrasting reports on whether this actually does anything?

thanks,

Jim

 

[spacejunk]

Dissolve it in propylene glycol.
Mix at 1mg/1mL or something, and heat gently if it doesn't dissolve with stirring.
Then dose with an oral syringe (or a syringe without a needle).

It's too potent to dose in anything other than liquid measurements.

Dose it orally. I'm not sure that insufflating would be effective, plus liquid dosing is the safest way.
It's a drug that needs to be treated with great care IMO

 

[JimJim]

Thanks for the reply.

i have no idea how to make a solution, where to get propylene glycol from or get a syringe. But i am prepared to do some research and find out.

in the mean time, using scales as described above would a dabbed finger still work in the interim? As i said before i take 10mg regularly (almost daily) and have taken over 20mg on some days, so whether i take 2mg or 4mg in one dab isn't really going to make much difference in my opinion i'm not too concerned about exact dosing in the interim whilst i sort out how to dissolve in PG etc

 

[Jabberwocky]

While your dapping idea might work out okay for someone with a high tolerance, it will never be even remotely safe with a 0.01 scale.
When your scale is showing 0.01 it could easily be 20-30 mg.
You need a 0.001 scale.
I wouldnt even consider mixing it with PG without a 0.001 scale, Etizolam is simply just too potent to be screwing around like that

 

[Pill__Head]

I have done exactly your " dabbling powder" method to ingest many, many, many MG's of Alprazolam powder.. It works wonders, a little powder on the tongue, wash down with water, BOOM.

I should just warn you, be very careful with this method..Its relatively, well, reckless.

 

[mind-explorer]

Get miligram scale but you still cant be sure if its accurate because changes in temperature, moisture and so on makes only little differences, but big enough to make a mistake at milligrams. Dissolve in propylene glycol and apply to blotters (can be bought on ebay for cheap) or another papers, jelly, whatever man.
I usually buy propylene glycol on net but you can find it in liquiud to ecigarretes and Im sure there are more places to buy it (hardware store?)
How to make solution? Use syringe to get 100ml propylene glycol, throw in 100mg etizolam and you get 1mg/1ml concentration. Simple as shit. You can dose from syringe or use lower ammounts of propylene glycol (not sure about solubility) to lay it on blotters . Ive seen alprazolam blotters so this shouldnt be a problem.

 

[JimJim]

yeah well i ended up doing the whole 250mg in one night (9 hours)……with little effect (!)

emailed my supplier and told them their product was sh!t and asked for refund / 50 complimentary Intas 1mg or 100 2mg non-lab tabs… see how that goes down 8(