Stimulants Dexamphetamine experiment (concentrated dexamphetamine powder)

[PeacePipeChief]

Ok so my theory is this :
Get say 10-20 , 5 mg Dexamphetamine pills , crush them up then put them into a cold water and mix it up then use a syringe with a filter and draw the solution (CWE) thus ridding of the fillers and bindings . then place into a tray (glass im pretty sure) and place into an oven at 60-70 degrees Celsius (140-158 Fahrenheit) in order to evaporate the solution thus turning it back into a powder . i read about this being done for codeine , so i dont see why not for Dexamphetamines . then scrape the reminents on the tray up and theres your powder , ready to use in any way you please .

the reason i thought of this is because i read it was possible to inject dexamphetamines using a filter in order to get rid of the fillers and bindings , but cold water must be used in order not to get a gluggy solution , this lead me to the thought of a CWE .
however doing this technique wouldnt be efficient to inject because in order to get a decent effect you would need a fair few pills , which would make the solution far too thick to draw into a needle . so using another tequnique i heard to turn a CWE into powder pure codeine i figure i can resolve this . you get your CWE and place it into an oven until it turns back into powder . if this is also possible with Dexamphetamine pills , then this would result in a much more concentrated powder for its mass . Would this work ?

any feedback on this would be excellent . thanks

 

[tricomb]

CWE's are done with opiates because opiates are freely soluble in cold water, whereas the APAP is less soluble at lower temperatures of water.

I have no idea whether this would work with speed pills, because there's no tylenol. Remember that even a CWE doesn't get rid of most binders in the pill (which seems to be your goal, separating the binders from the active ingredient), only the tylenol.

I am going to assume a CWE does not work to extract speed from pills.

 

[PeacePipeChief]

i researched a little bit and the dex is soluble in water and the rest can be filtered out , the dex must be in cold water though , otherwise it gets gluggy , so im guessing that the CWE part will work smoothly , im more worried about turning it back into powder , cause im not sure if itll work like codeine does . thank you for your response , have been waiting days for any response lol .

 

[Captain.Heroin]

I am going to assume a CWE does not work to extract speed from pills.

Of course it does. You can do a cold water extraction on dexedrine IR tablets to use it plugged instead of orally.

Many binders of dexedrine IR tablets are water soluble as well though.

 

[PeacePipeChief]

yeah hopefully the 'cold' water will reduce this as much as possible , i read about someone trying to IV dex and it went gluggy , in which they got a response saying "yes cold water is needed" because in warm water some of the binders are soluble . im really keen to find out about this though , if i can make a much more concentrated dexamphetamine powder out of a bottle of fifty , thats equal to half a gram of speed in dexamphetamine , which will be fun

 

[sekio]

if you are planning to inject, please use a micron filter.

This is not a smart idea anyway, and it looks like the thread has been answered...