So I recently found myself sick and searching and searching for...well any kind of opiate I could find ;( when I finally got in touch with a friend who said he could get me some dillies, come to find out they were exalgo 12 mg which I found out is extended release dilaudid, loving the needle as I do this was somewhat a disappointment even tho I was very exited to have found something to calm the pain I was in , in the past I've injected quite a few substances,(heroin, oxy,Roxy,dilaudid, methamphetamine, ketamine, etc, etc) and also here recently opana 40 (which are also ER) as well as the OP oxycontin, and as these exalgo 12 mg pills were very similar to the new OP's I decided there was surely a way to break these down for injection... So finally I'll get to the point...
Here what I did,
Scratch off the yellow coating
Then with a sharp pair of scissors cut the pill in half and realized it was incased in a plastic like shell, I took the scissors and carefully removed the plastic shell
(trying to lose as little of the actually pill as possible in the process)
Then "shaved" the pill into the smallest pieces possible into a spoon
Then heat (NO water) it will melt down and start turning to a golden brown "goo" in the spoon
Once it is all completely melted down, added 2 1cc syringes full of water and continued to heat until it was all mixed with the water
Then just throw in your cotton,(or micron filter if you actually have these)
And draw it all up, add a little cold water or give it a minute or two to cool
Btw, I'm not sure if this is exactly safe, but I personally haven't noticed any adverse reactions yet, and have been using this method for a few days now.
I'd have to compare the rush/buzz to that of opana, amazing!