lookinseedyjim
Bluelighter
- Joined
- Feb 12, 2004
- Messages
- 25
I have been curious about the effects of ived adderall for a while now, so tonight i took it upon myself to try it. Having seen Requiem a good number of times i am somewhat hesitant about shooting up although i have done it a few times. I am posting this to share my method which i think falls into the realm of harm reduction should a person choose to inject adderall. One small note about myself and my reason for believing i am qualified to offer this post: i have completed three years as a chem major at a university.
Two 20 mg adderall IR tablets were crushed and placed in a small glass. To this was added 5ml of distilled h20. the solution was heated slightly to aid in dissolving. once dissolved a very few crystals of naoh(red devil lye) are added. This results in a change in color from orange to red. The ph was tested and found to be 13. To was added 5ml of chloroform(any organic solvent should work) which resulted in two layers forming in the glass. This mixture was put in a 125ml erly. flask, stoppered and shaken vigorously. The bottom layer was drawn off by means of a syringe.
NOTE: chloroform is denser than water which is why its on the bottom however most organic solvents are less dense than water and so they would be the top layer. Know the nature of the solvent.
To this chloroform solution, again in the erly. flask, was added 5ml of distilled water followed by a few drops of 6M HCL. The solution was again shaken and the ph tested; found to be 2. The solution should now be acidic though i do not believe it makes much difference what the exact ph is. The top layer was decanted and placed on a plate. This plate was microwaved for 30 second intervals with a minute break in between each interval. The result was off-white crystals of amphetamine hcl. These were scraped, dissolved, pulled through a small segment of coffee filter, then shot.
This is a somewhat complicated procedure for a decent but not mindfuckingly good rush. I have read many posts of from people who have been curious for a safe way to shoot adderall and due to my own curiosity I tried this method and was pleased with the results. Anyone with more chemistry knowledge than I please let me know if you see any dangers from this. I believe it to be safer and subjectively better than simply dissolving adderall which I have also done(not wise).
PS: A simple way to obtain enough dh2o for an injection is to put a small amount of tap water in a bowl. Heat until boiling. Take off heat and place a small shot glass in the middle of the bowl. Cover the bowl with a piece of plastic wrap and place an ice cube and a little water on top of the wrap. The ice cube weighs down the wrap and creates a low spot which will serve as the point where all the condensed and now distilled water from the wrap will fall into the shot glass.
Be safe, but not so much you miss a chance to have fun.
the seediest of jims
One further piece of advise to anyone interested in trying this: when extracting the basic water with chloroform do two extractions of 5ml each and combine these as I noticed my yeild from this procedure was a little less than what I had calculated it to be after taking into account the change of salt.
Two 20 mg adderall IR tablets were crushed and placed in a small glass. To this was added 5ml of distilled h20. the solution was heated slightly to aid in dissolving. once dissolved a very few crystals of naoh(red devil lye) are added. This results in a change in color from orange to red. The ph was tested and found to be 13. To was added 5ml of chloroform(any organic solvent should work) which resulted in two layers forming in the glass. This mixture was put in a 125ml erly. flask, stoppered and shaken vigorously. The bottom layer was drawn off by means of a syringe.
NOTE: chloroform is denser than water which is why its on the bottom however most organic solvents are less dense than water and so they would be the top layer. Know the nature of the solvent.
To this chloroform solution, again in the erly. flask, was added 5ml of distilled water followed by a few drops of 6M HCL. The solution was again shaken and the ph tested; found to be 2. The solution should now be acidic though i do not believe it makes much difference what the exact ph is. The top layer was decanted and placed on a plate. This plate was microwaved for 30 second intervals with a minute break in between each interval. The result was off-white crystals of amphetamine hcl. These were scraped, dissolved, pulled through a small segment of coffee filter, then shot.
This is a somewhat complicated procedure for a decent but not mindfuckingly good rush. I have read many posts of from people who have been curious for a safe way to shoot adderall and due to my own curiosity I tried this method and was pleased with the results. Anyone with more chemistry knowledge than I please let me know if you see any dangers from this. I believe it to be safer and subjectively better than simply dissolving adderall which I have also done(not wise).
PS: A simple way to obtain enough dh2o for an injection is to put a small amount of tap water in a bowl. Heat until boiling. Take off heat and place a small shot glass in the middle of the bowl. Cover the bowl with a piece of plastic wrap and place an ice cube and a little water on top of the wrap. The ice cube weighs down the wrap and creates a low spot which will serve as the point where all the condensed and now distilled water from the wrap will fall into the shot glass.
Be safe, but not so much you miss a chance to have fun.
the seediest of jims
One further piece of advise to anyone interested in trying this: when extracting the basic water with chloroform do two extractions of 5ml each and combine these as I noticed my yeild from this procedure was a little less than what I had calculated it to be after taking into account the change of salt.
Last edited: