• Select Your Topic Then Scroll Down
    Alcohol Bupe Benzos
    Cocaine Heroin Opioids
    RCs Stimulants Misc
    Harm Reduction All Topics Gabapentinoids
    Tired of your habit? Struggling to cope?
    Want to regain control or get sober?
    Visit our Recovery Support Forums

Opioids How to inject opana er

I think you're an idiot.

Please, nobody listen to him. Trying to inject Opana ER is extremely difficult at best, life-threatening at worst. Heating up the crushed pill powder until it turns brown is PART of the process, but this idiot who can't even be bothered to type properly is leaving out quite a few steps.

Overall, Opana ER is much better off being snorted than IV'd. There are plenty of opiates out there to IV, for safety's sake its better to leave opana ER off the list.
 
^^This is true, but from what I've read, the "big deal" about OM is that when IV'ed, the level and quality of euphoria is close to, or better than IV heroin. This is why there is such a demand to find a good IV method, regardless of it's danger.

Anyway, I've read elsewhere, that the easiest way to extract most of the OM from the pill is to avoid crushing, as this is what locks in the OM. Simply drop the whole pill AS IS into some water. 12 hours later, the gummy matrix that surrounds the OM has expanded (opens up), and the OM is released into the water solution. Just filter, and inject. Those where I read this think 60-80% is being obtained this way, which is pretty good IME.
 
i had a 40mg opana. using the etoh method i definetly got a nice rush, even being on suboxone but i felt like i wasted a lot of it. probably would have gotten higher off of snorting it. the soaking in water for several hrs until the gel just precipitates to the bottom of solution sounds promising but no junkie has that patience.
 
When all else fails and you don't know what to do, plug if popping stopped getting u off.
 
the soaking in water for several hrs until the gel just precipitates to the bottom of solution sounds promising but no junkie has that patience.

What requires more patience, soaking a pill in water for 12 hours, or constantly needing to go through the hassle of copping more opana pills because you're going through them too quickly? Not trying to be rude, but I'd like to point out that you can make enough solution for a week in the same 12 hours (e.g. soaking more than one). If just do it all beforehand, you'll have the solution ready instantly every time. until its gone.

Because of the higher yield of OM this way, you will be getting more mileage from each pill, and this saves you time and money.
 
If I had Opana which I really want to try, I would snort it and not waste a pill trying to IV it.
 
i was actually at the library and ended up talking to this guy randomly. turns out we are both junkies. we exchanged stories and he told me he was on opana. i was like no way, i would love to try that stuff. so he reaches into his backpack and procures one yellow stop sign of lovely oxymorphone. i was like HOLY SHIT, this guy kicks ass. i didnt get his number because im a recovering addict and dont want to return to the abyss. but fuck, i would like one more go at it now that i know the water soaking has efficient yields. i should have just snorted it. oh well. for now ill just take my suboxone and mix it with some benadryl for when i have the urge to feel some altering of consciousness.
 
i was actually at the library and ended up talking to this guy randomly. turns out we are both junkies. we exchanged stories and he told me he was on opana. i was like no way, i would love to try that stuff. so he reaches into his backpack and procures one yellow stop sign of lovely oxymorphone. i was like HOLY SHIT, this guy kicks ass. i didnt get his number because im a recovering addict and dont want to return to the abyss. but fuck, i would like one more go at it now that i know the water soaking has efficient yields. i should have just snorted it. oh well. for now ill just take my suboxone and mix it with some benadryl for when i have the urge to feel some altering of consciousness.

Yea I gotta say chewing them almost seems criminal in my mind. Maybe its a good thing in your situation though considering Opana can be powerfully persuasive to an addict. If you got the yellow ones like I take, 40's, then it may be good you didnt rail it if you have been clean for a bit and your tolerance is low, its very very potent stuff.
 
^^This is true, but from what I've read, the "big deal" about OM is that when IV'ed, the level and quality of euphoria is close to, or better than IV heroin. This is why there is such a demand to find a good IV method, regardless of it's danger.

Anyway, I've read elsewhere, that the easiest way to extract most of the OM from the pill is to avoid crushing, as this is what locks in the OM. Simply drop the whole pill AS IS into some water. 12 hours later, the gummy matrix that surrounds the OM has expanded (opens up), and the OM is released into the water solution. Just filter, and inject. Those where I read this think 60-80% is being obtained this way, which is pretty good IME.

I'm curious on this myself.
At one point I was making nasal sprays out of the IR's & it worked relatively decent.
I've tried the method your mentioning above.
I'm guessing we may have read it in the same place :)
Long story short I used the resulting water to make a nasal spray.
Subjectively it didn't seem like it worked very well.
The spray I made from the ER seemed to be about 50% as strong as the spray I made from the IR.
It's been a while since I did this experiment but as far as I recall those were the results.
So I'm quite curious as to whether others have had success with that method.
I don't IV but seeing as methods for prepping nasal sprays & IV prep methods are sometimes somewhat similar I figured I'd ask.
Note that when I did this experiment I tried 12/24/36 hours respectively & seemed to get equally disappointing results.
I also tried this using saline rather than water as saline tends to be a bit better for sprays & didn't notice a difference.
Anyways, that's my experiences with that particular method & am quite curious as to what I may have done wrong if it works for others.
I was under the impression that it just wasn't as efficient as I'd been led to believe.
Perhaps I was wrong?
 
I really want to try this, but have never iv'd ANYTHING. been snorting my opana's for 3 years now & am over it. in the posts with instructions on how to do it, what is "cotton"? what kind of cotton am i supposed to use? cotton balls? cotton toilet paper? cotton t-shirt? how much is supposed to be used? and what exactly is the cotton for? like, exactly what am i supposed to do with the cotton? use it as a filter & then draw up whatever solution ran through the cotton? or draw it out the actual piece of cotton? (which seems impossible in my brain). i once heard a guy say he used cigarette filters as the cotton. any opinions on that? also, is the micron filter people have talked about an actual gadget/machine that filters the solution or is it just a piece of filter material? i must apologize for the stupid questions - i just really don't know anything about this stuff. i need some really detailed, step-by-step instructions. no detail is too small. also, i only could get my hands on some 1cc, 29 gauge, 1/2" syringes. are those okay to use? any tips would be most helpful. again, i have NEVER shot anything, never even seen it done & don't have anybody to show me how. any tips would be most appreciated, because i'm a bit confused which way to go after reading all this. oh, and i'm referring to the ER's. i currently have a bunch of 15mg ER's & my tolerance is pretty high. need to snort bout 70 - 80mg at one time to barely get an acceptable effect. but, lately, it seems it doesn't matter how much i suck up my nose - they're just not working & i want to try something different. of course, i'd rather not waste them trying to figure this out. so, any guidance i can get both on how to prepare the pills & also how to actually inject them would be great (i have no clue how to inject - how far to go in, what it feels like - nothing). one last question: why can't i just scrape off the coating, drop it in a glass of water (either whole or crushed), wait for it to dissolve & then draw it up into the syringe directly from the glass? from what i've read, that is bad bad bad, but i'd like to know why.thanks.
 
Last edited:
I've been trying to read as much as I can about this before I try it, and came across something that has me a bit scared...The following is an excerpt from a different site. Has anybody had a similar experience or know if there is any validity to this:

".....Second I DO NOT recommend shooting the Opana ER's because these contain silicified microcrystalline cellulose, in other words silica which is very poisonous and harmful to your veins and lungs. Regular Opana's DO NOT contain silica and are way less harmful to inject. Every time I have injected Opana ER's about 45 minutes to 1 1/2 hours later I get extreme uncontrollable shakes. It's almost like a seizure except you're conscious for and I would know because I have had 3 Gran Mal Seizures in the past 4 years. The shakes are caused from the silica which when shot compress your lungs and both your blood pressure and oxygen levels are severely decreased. If you still wish to shoot Opana ER's despite my warning when you do get the shakes take big, deep, steady breaths. I have found that this helps a great deal. Right after the shakes go away, which they last about 30 minutes, you get extremely high so it's almost worth the risk, ALMOST....."
 
can i just let it dissolve in 1ml bacardi and inject that? did it w xanax before and it waspretty good.
 
can i just let it dissolve in 1ml bacardi and inject that? did it w xanax before and it waspretty good.

No, that's a fucking god awful idea. What happens is ethanol causes ethanol embolization. You need to dilute 40% ethanol with water, to the point where the amount of ethanol is at least below 10%.

Furthermore, you need to filter the pill particles, ideally with a micron filter.
 
shit ok, not that i know really what that means bu, wtf, ill trust you :)

Ethanol embolization is a process of injecting ethanol for the purposes of collapsing a vein (or other blood vessel). This would be useful, medically, if you wanted to selectively remove blood vessels leading to/from a tumor, to inhibit its growth.

If you don't dilute ethanol enough, it can cause your vein to permanently collapse.
 
Ok people. just so you know how bad this pill is, I have been to the ER twice and I have only had my script for 2 days! I have been taking it the way your suppose to take it (orally)and it has cause severe chest pain and incredibly bad headaches as well as some nasty toxic side effect like anxiety and anger. I am going to my pain specialist and having him remove me from this pill completely,we are being use for guinea pigs, it has not been test as well as it should have been. If your think I am pulling your leg Google death from Opana er to see what I am talking about. You can do what you want but the pill is a 0 in my book, I dont care how strong it is. Have fun, be safe and don't kill your self for a high.
 
I finally got my hands on an opana er 40mg. before going through the trouble of the alcohol method of extraction, i decided to try the "browning in the dry spoon method" first, because I am lazy. I was happily surprised that it worked like a charm. I was able to get about 8-10 nice shots out of the one pill. What I did was this: took coating off. ground the pill finely. separated powder into ten little piles. put one pile in large spoon. used strong lighter from underneath to brown powder, stirred the browning powder with a key periodically until it had all turned dark brown but not black. Then I added 1 1/2 cc of water. Half a cc burns off because of the hot spoon so you are left with a nice amber color 1 cc shot. No gel whatsoever. pulled through cotton twice just for safety sake and shot the shit up. The high was pretty good, felt like a mix between dilaudid and morphine. I would take banging 2-3 roxies instead any day but I wouldn't kick the opana out of bed either. Hope this was helpful to someone.
 
My Opana Injection Method

I would like to relate my Opana injection method:

Get a bottle of the 90% isopropyl or preferably ethyl alcohol from the pharmacy.

Break the pill up, and remove as much of the coating pieces as you can. they usually stay in large chunks and separate easily from the powder. the coating pieces make a thicker finished product (this is bad).

add about a syringe full of alcohol to the crushed up pill in a spoon. mix it up until the alcohol turns into a white, milky mixture. It should still be thin enough to suck back up into a 28g needle. drop some cotton in the spoon and extract the liquid from the pill (save the residue, it can be reused 2-3 times).

put the alcohol mixture into another spoon (tablespoon preferably), and slowly heat it with a lighter, allowing the alcohol to evaporate. don't heat it too much or the good stuff will stick to the spoon as the liquid dissipates.

once you have only 20cc or less of alcohol left, you should be able to add enough water in one syringe to inject the mixture without much pain or other problems.

you can either suck the alcohol then the water up, or you can put 80cc of water into the spoon and then use cotton again to filter any chunks that might develop from the remaining binders. I find that once water and the opana are mixed in the spoon, it can still be difficult not to clog up the cotton too bad. I always just mix it in the syringe.

BE CAREFUL. As we have discussed, IV oxymorphone is far far stronger than oral or intranasal use. Unless you have a hell of a tolerance like I do, don't do a whole 40mg pill at once!
 
Top